DAPAudio PSS-110 MKII Manual
Also see for PSS-110 MKII: Product guideManual
                | |
Ordercode: D2609PSS-110 MKII01) Press the cover (1) down, in the direction of the arrow.02) Slide the cover (2) in the direction of the arrow.03) Insert the battery. Please mind the correct polarity when inserting the batteries.04) Close the battery cover.Tips For Achieving Maximum Performance• Make sure you can always see the receiver antenna from the transmitter position.• Keep the distance between the transmitter and the receiver antenna as short as possible.• Point the receiver antennas away from each other, at an angle of 45° from vertical position.• Avoid placing the receiver antennas near metal surfaces and obstructions.• Replace the battery as soon as the low battery indicator LED lights up.• Perform a walk-through before performance or presentation. If dead spots are found, adjust thelocation of the receiver. If dead spots remain, mark the dead spots and avoid them.MaintenanceThe DAP Audio PSS-110 MKII requires almost no maintenance.However, you should keep the unit clean.Disconnect the mains power supply, and then wipe the cover with a damp cloth. Do not immerse inliquid. Do not use alcohol or solvents.Keep connections clean. Disconnect electric power, and then wipe the audio connections with a dampcloth. Make sure connections are thoroughly dry before linking equipment or supplying electric power.Replacing the FusePower surges, short-circuit or inappropriate electrical power supply may cause a fuse to burn out. If thefuse burns out, the product will not function whatsoever. If this happens, follow the directions below.01) Unplug the unit from electric power source.02) Insert a screwdriver into the slot in the fuse cover. Gently pry up the fuse cover. The fuse will comeout.03) Remove the used fuse. If brown or unclear, it is burned out.04) Insert the replacement fuse into the holder where the old fuse was. Reinsert the fuse cover. Be sure touse a fuse of the same type and specification. See the product specification label for details.TroubleshootingNo SoundAlways check if all the cables and cords are connected. Always turn off power to the area beforechecking the wires, to prevent electric shock.If everything works properly and there is still no sound, revisit the manufacturer’s instructions to make surethey were followed during installation. If everything was installed correctly and there is still no sound, youmay want to consider bringing in a professional to take a look at your speaker.If the speakers do not operate properly, refer servicing to a technician.Suspect three potential problem areas as: the power supply, the speakers, the fuse.01) Power supply. Check if the unit is plugged into an appropriate power supply.02) The speakers. Return the PSS-110 MKII to your DAP Audio dealer.03) The fuse. Replace the fuse. See page 12 for replacing the fuse.04) If all of the above appears to be O.K., plug the unit in again.05) If you are unable to determine the cause of the problem, do not open the PSS-110 MKII, as this maydamage the unit and the warranty will become void.06) Return the device to your DAP Audio dealer.12 |
Related manuals for DAPAudio PSS-110 MKII
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine