©National Instruments Corporation2-1SCXI-1102/B/C User ManualChapter2Configuration andInstallationThis chapter describes how to configure your SCXI-1102/B/C jumper,how to install current-loop receivers, and how to install yourSCXI-1102/B/C module into the SCXI chassis.Module ConfigurationThe SCXI-1102/B/C contains one jumper, shown in Figure 2-1. JumperW1 connects a pullup resistor to the SERDATOUT signal on the rearsignal connector.The remainder of the module configuration (gain, output signalreferencing, and so on) is software-programmable.
