DART Controls 65E Series Instruction Manual
Also see for 65E Series: Instruction manualInstruction manual
                    | |
Pot High (P2-1)Pot Wiper (P2-2)Pot Low (P2-3)Common (P2-4)Inhibit (P2-5) 5KSpeedpotOrangeRedWhiteSPST Switchopen = stopclose = runP2Pot High (P2-1)Pot Wiper (P2-2)Pot Low (P2-3)Common (P2-4)Inhibit (P2-5)P2SPST Switchopen = runclose = stopInhibit via speedpot - provides starting andstopping through accel/decel parametersUsing inhibit input - provide fast start-stop by bypassing accel/decel circuit+-+-BatteryCaution:Motor and battery wire mustbe a minimum of 12 ga. anda maximum of 6 ga.+-BatteryCaution:Motor and battery wire mustbe a minimum of 12 ga. anda maximum of 6 ga.WhiteMotorCustomer supplied3PDT Center-offCenter-blocked switchRelays may be used in place of switch, but a neutral position must be providedto prevent plug reversing. Do not engage opposite direction until motor hascome to a complete stop. Failure to do so may result in damage to the control.Pot High (P2-1)Pot Wiper (P2-2)Pot Low (P2-3)Common (P2-4)Inhibit (P2-5)+Arm (P1-5)+Battery (P1-4)No Connect (P1-3)-Arm (P1-2)-Battery (P1-1)5KýSpeedpotOrangeRedWhiteCurrent Limit Max SpeedAccelI.R. Comp.Min SpeedMotorOptionalInhibit(see hook-upbelow)Pot High (P2-1)Pot Wiper (P2-2)Pot Low (P2-3)Common (P2-4)Inhibit (P2-5)+Arm (P1-5)+Battery (P1-4)No Connect (P1-3)-Arm (P1-2)-Battery (P1-1)5KýSpeedpotOrangeRedCurrent Limit Max SpeedAccelI.R. Comp.Min Speed+ +OptionalInhibit(see hook-upbelow)Customer suppliedSPST switchCustomersuppliedSPST switch+ +P1P1P2P2Note: Always use a shielded cable when connecting to the inhibit terminal. The shield of the cable should connect to the Commonterminal of the control.65E SERIES HOOK-UP DIAGRAM3 (continued on following page)(continued)65E REVERSING HOOK-UP DIAGRAMINHIBITING THE CONTROLTRIMPOT ADJUSTMENTSBefore the power is applied, the speed potentiometer and trimpots should be preset as follows:TRIMPOT PRESET1. Preset speedpot fully CCW, preset Max trimpot CW 1/2 way, preset Current Limit trimpot fully CW, preset Min trimpot fullyCCW, preset Accel trimpot CW 1/2 way, preset I.R. trimpot fully CW.DC power can now be applied to the system and the control adjusted as directed below:TRIMPOT ADJUSTMENT2. Increase the MIN trimpot in a clockwise direction until the desired minimum speed is reached.3. Turn the Speedpot fully clockwise and adjust the MAX trimpot until the desired maximum speed is reached. |
Related manuals for DART Controls 65E Series
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine