DAS HDJ-2450 User Manual
           | |
OPERATIONS11. Matching the Beats Per Minute (BPM)There are three tools available for matching the BPM of the two CDs:Å Use the pitch slider to adjust the BPM satirically.Ç Use the PITCH BEND buttons to change the BPM temporarily.É Turn the JOG dial to change the BPM temporarily.1) Pitch Sliderå To adjust the BPM by sliding the pitch slider up or down, press the PITCH button to turn on the PITCH adjustmentfunction before useing.ç Slide the pitch slider up to decrease BPM, or down to increase BPM. The adjustment range is +/-8,+/-12,+/-16%.2) Pitch Bendingl The BPM increases or decreasesrespectively while the PITCH BEND+ orPITCH BEND- button is pressed.l The BPM increase depends on how longyou hold the button. If you hold the buttonfor about 1/2 second, theBPM will go eitherto +16% for PITCH BEND+ or -16% forPITCH BEND-. If you tap the button, theBPM will only change a little so you canchange the beat slightly without audiblechanges in the music.l The CD will return to the tempo indicatedby the Pitch slider when you let go to the PITCH BEND+ or -.l Figure 11 shows an example of how to use the pitch bend function.In this example, both players are playing and the BPM has alreadybeen matched with the pitch sliders.The bass beats also matchCD1 Bass beatbass beat PITCH BENDCD2bass beatBass beat Figure 11-13) Turn the JOG dialTurn the jog dial clockwise during play to increase the BMP in the forward direction, counterclockwise to decreasethe BMP in the reverse direction. The faster you turn the wheel, the more the BMP changes. The BMP changes witha range of +/-8,+/-12,+/-16%.When you release jog wheel, the CD will return to the tempo indicated by the pitch slider.12. Program playå Press the PROGRAM button, the player will enter the program mode and the CD will stop rotating.ç Select the desired track by pressing the SKIP button, then press the PROGRAM button again. The selectedtrack will be added to the program sequence.é Repeat step 2 operation. A maximum of 20 tracks can be programmed at one time.è Press the PLAY/PAUSE button to start the program play from the first selection.ê Press the program button again during program play to stop play.ë Press and hold the program button more than 2 secords to cancel the program mode and erase all the currentprogram contents.13. Loop Playå Press the LOOP button to set the loop start point A, the LOOP indicator will flashes on the LCD.ç Press the LOOP button again to set the loop end point B, after the B point is set, the playback will enter the loopplay from A to B repeatedly.é Press the LOOP button again, the loop play function is canceled, the LOOP indicator goes out.14.Relay PlayPress PROG and SGL button to switch relay function; the indicator on the LCD track display when flash when relayis on.15. Fader startYou have the possibility to start the respective CD-player directly from the mixer. Make sure that the Control socket isconnected with the respective socket on the mixer. Additionally, the Audio out socket have to be connected with theLine-input sockets of your mixer. Please note that the Fader start function only works with the appropriate mixers.Insert the CD and select the desired track. Start playback from your mixer. |
Related manuals for DAS HDJ-2450
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine