DBI SALA Exofit Instructions Manual
Also see for Exofit: User instructions
                                | |
24IMPORTANT: An excessive buildup of dirt, paint, etc. may preventthe full body harness from working properly, and in severe casesdegrade the webbing to a point where it weakens and should beremoved from service.• Use extra rinse cycle to be sure all residual wash chemicalsare removed.• Air dry or tumble dry using permanent press cycle and lowheat. Drying temp should not exceed 200°F (93°C). Thesefabrics dry quickly, for lowest shrinkage, do not over dry.More information on cleaning is available from Capital Safety. If you havequestions concerning the condition of your harness, or have any doubtabout putting it into service contact Capital Safety.6.2 Additional maintenance and servicing procedures must becompleted by a factory authorized service center. Authorizationmust be in writing. Do not attempt to disassemble the unit.6.3 Store the full body harnesses in a cool, dry, clean environment outof direct sunlight. Avoid areas where chemical vapors may exist.Thoroughly inspect the full body harness after extended storage.7.0 SPECIFICATIONS7.1 PERFORMANCE• Maximum Free Fall Distance: No greater than 6 ft (1.8 m),per federal law and ANSI Z359.1.• Maximum Arresting Force: 1,800 lbs. (13 kN)• Maximum Capacity: 420 lbs. (191 kg)• Approximate Weight:Harness only: 3 lbs. (1.4 kg)Harness with Side D-rings: Add 1/2 lb. (.23 kg)Harness with Front D-ring: Add 1/4 lb. (.11 kg)Harness with Back Pad or Belt: Add 1 lb. (.45 kg)Figure 19 - Retrieval Harness D-ringsOpenings for D-rings Pull D-rings throughopenings The retrieval harnesspads have openingsfor the shoulderD-rings. Whenreplacing the pads,make sure the D-ringsare located on theshoulder straps sothat they protrudethrough the openingsand are available forconnecting retrievalsystems. |
manualsdatabase
Your AI-powered manual search engine