DCI Edge 5 Series Installation Instructions Manual
Also see for SERIES 5: Instructions for useInstallation instructionsInstallation instructionsInstructions for useInstallation instructions
             | |
CHAIR PREPARATIONSHIPPING BOLT1 Rotate the backrest into position by aligningthe backrest bottom holes to the holes in thelink bar which extends from the upper hydraulicassembly.2 Loosen the set screw which secures the steelcross pin. Align the holes of the backrest andthe back link and re-insert the cross pin. If neces-sary, use a rubber mallet to drive the pin until it hasfully engaged both parts.3 Tighten the set screw on the backrest linkagainst the pin to prohibit its movement.Remove the shipping bolt by unscrewing fromabove the seat pan casting using a 3/8” wrench.Once unscrewed, removed the bolt and relatedhardware from the assembly.Power Switch Cover: Install the power switchcover into the opening around the power switchby snapping it firmly into place.Foot Switch: Unpack the foot switch and set inposition for use.POWER SWITCH COVERFOOT SWITCHBACKREST FOOTPADPRESET POSITION “1”PRESET POSITION “0”RETURN TO LAST POSITION6SERIES 5 DENTAL CHAIRInstallation Instructions |
Related manuals for DCI Edge SERIES 5
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine