DCS CS-364G Installation Manual

Also see for CS-364G: Installation guide Installation guide

Contents

DCS CS-364G Installation Manual Manual pdf 7 page image

UNPACKING AND HANDLING6STEP 1:MOVING AND PLACING THE COOKTOPNOTE: If a solid side cabinet wall exists on one or both sides, you will need to notch thefront corner of the cabinet to match the counter top notch and to provide clearancefor the cooktop front (see page 8).CAUTION:Proper equipment and adequate manpower must be used in moving thecooktop to avoid personal injury or damage to the unitANCHORING THE COOKTOPThe cooktops have a shipping weight of approximately 228 pounds (36" models) and 324 pounds (48"models). After removal of packing materials, it is recommended that the grates and drip pan (belowknobs) be removed to facilitate handling. This will reduce the weight to about 150 pounds. DO NOT REMOVE THE GRILL OR GRIDDLE ASSEMBLIES.It may be necessary to remove the cooktop knobs to pass through some doorways. With the knobsremoved a 29-3/8" wide opening is required. Remove the outer carton and packing material from theshipping base. The cooktop is held to the skid by four straps. After removing the straps, the cooktopmust be lifted and removed from the skid.The professional cooktop should be moved close to its final location. Electric and gas connectionsshould be made (steps 5 & 6 pgs. 12 & 13) and the backguard installed (as required, step 4 pg. 11)before the cooktop is placed in its final position. The grill and griddle sections are fastened in place atthe front with screws. They are designed to be stationary and not meant to be removed for cleaning.The griddle has two leveling screws beneath the rear flue cover which can be used to adjust thegriddle to the desired slope. The center screw is for shipping and should be removed. Due to the weight of the cooktop, along with a built-in side frame gasket that is meant to rest andcreate a seal on the counter top once installed, it is not necessary to anchor the unit to the counter.