DCS RGTC-305 Installation Manual

Also see for RGTC-305: Use and care guide Use and care guide

DCS RGTC-305 Installation Manual Manual pdf 14 page image

12INSTALLING ANTI-TIP DEVICEAll ranges must have an anti-tip device correctlyinstalled as per the following instructions. If you pullthe range out from the wall for any reason, make surethat the device is properly engaged when you pushthe range back against the wall. If it is not, there is apossible risk of the range tipping over and causinginjury if you or a child stand, sit or lean on an openoven door.INCLUDED PARTS:(4) #10 x 2” wood screws,(1) Anti-tip bracket, and (1) Installation Instructions.INSTALLING THE KIT:Instructions are provided for wood and cement floors.Any other type of construction may require specialinstallation techniques as deemed necessary toprovide adequate fastening of the Anti-tip bracket tothe floor and wall. The use of this bracket does notpreclude tipping of the range when not properlyinstalled.WOOD CONSTRUCTION:Place the bracket against the back wall, into the rightrear corner where the range is to be located. Leave agap between the wall (or side of range) and the bracket of 3/4”(see Fig. 10). Drill (2) 1/8” diameter pilot holes in the center ofthe small holes. A nail or awl may be used if a drill is notavailable. Fasten the bracket securely to the floor and wall.CONCRETE OR CEMENT CONSTRUCTION:Hardware Required:(2) sleeve anchors, lag bolts, and washers (not provided).Locate the bracket as described above. Drill the recommendedsize holes for the hardware. Install the sleeve anchors into theholes and then install the lag bolts through the bracket. Thebolts must be properly tightened as recommended for thehardware. Fasten the bracket securely to the floor and wall.ONCE INSTALLED:Complete the range installation per the instructions providedwith the product. Check for proper installation of the range andAnti-tip device by grasping the back of the unit and carefullyattempt to tilt the range forward.WARNINGALL RANGES CAN TIPINJURY COULD RESULTINSTALL ANTI-TIPBRACKET PACKEDINSIDE OVENSEE INSTRUCTIONSFig. 11Fig. 10(2) LARGE HOLES FOR CON-CRETE INSTALLATIONS(2) SMALL HOLES FORWOOD INSTALLATIONS(2) WOOD SCREWS INTOBACK WALL (ALL INSTALLA-TIONS)BACKWALLRIGHT SIDE OFWALL OR RANGE3/4”