DCS WD-27-SS-OD Use And Care And Installation Manual

Also see for WD-27-SS-OD: Specifications

DCS WD-27-SS-OD Use And Care And Installation Manual Manual pdf 10 page image

8INSTALLATION INSTRUCTIONSMOUNTING INSTALLATIONThe lower rear corners of the cabinet need to provide proper support to the back of the Warming Drawer and theanti-tip mounting clips. A 120 volt AC 15 amp minimum (GFI) outlet should be located no further than 36 inchesfrom the back center of the Warming Drawer. Illustrations suggest one possible bottom support, but theconsumer is not limited to this idea for mounting configuration.STEP 1The bottom rear section of the cabinet should be made of moisture protected 2x4 and needs to be installed tohold the anti-tip mounting clips and support the weight of Warming Drawer, which is 90 lbs. If moistureprotected 2x4 is used, a min. 3” diameter hole through the wood needs to be provided for water drainage. Holelocation must correspond with drain in bottom of unit.STEP 2Use the screws provided to attach the mounting clips which must be installed for anti-tip safety to the bottomsupport at the back. See placement dimensions in figure 05.STEP 3The Warming Drawer has slots on the back side where it will slide onto the anti-tip mounting clips.Plug power cord into the AC outlet. See figure 06.STEP 4Fasten the front face to the cabinet by passing the screws through the holes of the front face of the warmingdrawer to finish the installation. See figure 07.NOTE: The bottom support made of moisture protected 2x4 runners or other moisture protectedconstruction must be capable of supporting the weight of the warming drawer. A drain hole MUSTbe provided for drainage.Slide draweron to Anti-Tipmounting clipsmounting clips21-1/2”Fig. 05