DEFEWAY D5010WH4 User Manuald5010wh
                             | |
USER' S MANUAL OF EMBEDDED DIGITAL VIDEO RECORDERPage 21 of 273.8.3.7 PTZ ControlSelect ”PTZ setup” in “system setup”Channel: Choose the right channel, click the select box to chooseProtocal: The selected one must be the same with the one of PTZ camera.Device ID: Input the address of appointed decoder.Baudrate: Choose the matched one of the PTZ camera.Copy to: Choose the object route in the right select box, click the button of copy setting, then the information ofsetting will be showed, which also can be applied in other object routes.After the setting, click the button of sure to exit with saving save the changes, or click the button of “cancel” toexit without saving.3.8.3 8 Sensor setupIn system setup , choose "PTZ setup",enter setting interfaceChannel: Choose the right channel, click the select box to chooseWork mode: Setting to start alarm or notAlarm duration: Set up alarm duration timeRecording channel: When alarm is triggered, channel needed to be recordedAlarm: “√” enable alarm, “□” close alarmBuzzer: “√”start buzzer, “□” close buzzerE‐Mail notice ：“√” means E‐Mail valid，“□” means E‐Mail invalidCopy to: Choose the target channel in the right select box, click" copy to" ,the setting information will be appliedto other channel.After the setting, click "OK" to exit with saving save the changes, or click "cancel" to exit without saving. |
manualsdatabase
Your AI-powered manual search engine