DELTA DORE Micro TYBOX H RADIO X2D Manual
Contents |
1) Characteristics• Power supplied by three 1.5 V alkaline batteries oftype LR03 or AAA (last for more than 1 year)• Battery replacement indicator• Insulation class III• Mode selector switch (7 positions)• Choice of 3 permanent temperature settings - Frostprotection, Night-time temperature, Daytimetemperature - and one user-programmable cycle perday• The 3 temperature settings can be programmed asfollows : between 5° and 30°C for Night-timeand Daytime temperaturesand between 5° and 15°C for Frost protection• Proportional-plus-integral control (category B), timebase 15 min• Stand-by mode• Transmission frequency : 433 MHz(Standard I-ETS 300 220)• Average range between transmitter and receiver :100m outside, 30m inside.• Addresses: 65536 combinations• Digital display• Enclosure dimensions: 128 × 85 × 31 mm• Wall mounting or on base• Degree of protection: IP 30This system is incompatible with items of wirelessequipment which operate on the same frequencyband (433 MHz), in permanent transmission mode(headphones, wireless loudspeakers...) as they mayinterfere with the signal.1111 2222 33334444 5555 6666 7777WARRANTYThis thermostat is guaranteed for three years from itsdate of delivery.To benefit from this guarantee, a proof of purchasebearing the date of acquisition must be enclosed withyour faulty thermostat when you return it.The guarantee covers replacement of faulty parts,labour, and return shipping to the customer.The following are excluded from the guarantee :- thermostats whose serial numbers have beendamaged, altered or erased,- thermostats whose installation or use did notconform to the instructions given on the device orin the manual,- thermostats modified without prior agreement fromthe manufacturer,- thermostats damaged by impacts.Equipment conforming to the requirements of directivesCEE 89/335 (Electromagnetic Compatibility) and CEE 73/23amended by CEE 93/68 (Low voltage safety). Receiver :• If the green pilot lamp (OK) lights up continuously,the receiver has already been programmed.To reprogram, keep the button pressed for 10seconds until the green "OK" lamp starts to flashslowly, then release it.Press the button on the receiver again.The green "OK" lamp lights up continuously, the receiverhas been reprogrammed.• If the green pilot lamp (OK) flashes slowly, thereceiver has not been programmed.Press the button on the receiver again. The green"OK" lamp lights up continuously, the receiver hasbeen reprogrammed. Press the key on the transmitter to leaveprogramming mode. The receiver's output executes thetransmitter's command.The red pilot lamp indicates the state of the contact.On = Contact Off = No contact3.4 Checking the quality of transmission Turn the transmitter switch to the position. Press the button (3 sec.) until tESt appears on thedisplay.The transmitter sends itsdata to the receiver.The green OK lamp flashes 3 times every time data isreceived correctly. Press the button to leave transmission test mode.3.5 A Problem?The green "OK" lamp is flashing (the receiver has notreceived any data for more than an hour).1) Check the batteries in the transmitter2) Enter transmission test mode- If the green "OK" lamp does not flash (3 times) everytime data is received move the transmitter to anotherposition- If the problem continues, reprogram both devices.2) Installation2.1Choice of location2.1.1 Radio transmissionThe location of the thermostat should be chosen carefullyas some furnishings could absorb or reflect the radiotransmissions.We therefore advise that the mode of transmission andthe quality of reception is checked last (§ 3.4).2.1.2 Temperature measureThe thermostat must be positioned correctly. Therecommended height is 1.5 m in an accessible place,away from heat sources (fireplace, sunlight) and draughts(window, door).If the thermostat is mounted on its base, it can be used asa real heating remote control and so you can take it withyou wherever you are.2.2 Mounting2.2.1 Wall mountingIn order to mount the thermostaton the wall, it must be separatedfrom its base, as shown in figure 1.The base is then fixed to the wallusing screws and plugs or on aflush-mounting box (centre-to-centre distance 60 mm) using theholes .2.2.2 Base mountingThe thermostat has a foldaway base and can be usedaway from its wall mounting. For example it can be placedon a table or other furniture. It must be remembered thatits location could have an effect on the transmission of theradio signals and that it must be kept away from directheat sources and draughts (§ 2.1).1,50 mMini 20 cm3) Set up3.1Battery installationYour thermostat is powered by three 1,5V alkalinebatteries, type LR03 or AAA.See user guide on the back (§ 5).3.2Time settingSee user guide on the back (§ 6) .3.3 Programming / ReprogrammingIn the programming mode, every receiver can beallocated a transmitter. (When extending your system, itis possible to program several receivers to onetransmitter without any problems). Additionally, thismode is also used for checking the transmitting quality. Turn the transmitter's selector switch to the position Press the button(3 sec.) until CnF appears on the display.The transmitter sends itsdata to the receiver |
Related manuals for DELTA DORE Micro TYBOX H RADIO X2D
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine