DEMOAC MCF51AC256 Hardware User's Manual
                 | |
D E M O A C U S E R G U I D E A P R I L 1 0 , 2 0 0 84CAUTIONARY NOTES1) Electrostatic Discharge (ESD) prevention measures should be used when handling thisproduct. ESD damage is not a warranty repair item.2) Axiom Manufacturing does not assume any liability arising out of the application or use ofany product or circuit described herein; neither does it convey any license under patentrights or the rights of others.3) EMC Information on the DEMOAC board:a) This product, as shipped from the factory with associated power supplies and cables,has been verified to meet with FCC requirements as a CLASS A product.b) This product is designed and intended for use as a development platform for hardwareor software in an educational or professional laboratory.c) In a domestic environment, this product may cause radio interference in which case theuser may be required to take adequate prevention measures.d) Attaching additional wiring to this product or modifying the product operation from thefactory default as shipped may effect its performance and cause interference with otherapparatus in the immediate vicinity. If such interference is detected, suitable mitigatingmeasures should be taken.TERMINOLOGYThis development board applies option selection jumpers. Terminology for application of theoption jumpers is as follows:Jumper on, in, or installed = jumper is a plastic shunt that fits across 2 pins and the shunt isinstalled so that the 2 pins are connected with the shunt.Jumper off, out, or idle = jumper or shunt is installed so that only 1 pin holds the shunt, no 2pins are connected, or jumper is removed. It is recommended that the jumpers be placedidle by installing on 1 pin so they will not be lost.Cut-Trace – a circuit trace connection between component pads. The circuit trace may becut using a knife to break the default connection. To reconnect the circuit, simply install asuitably sized 0-ohm resistor or attach a wire across the pads.Signal names followed by an asterisk (*) denote active-low signals. |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine