DURKOPP ADLER 745-34-2 Installation Instructions Manual

Also see for 745-34-2: Operating and installation instructions Operating instructions Installation instructions User manual Programming instructions

DURKOPP ADLER 745-34-2 Installation Instructions Manual Manual pdf 29 page image

With the delivery of the machine only the test software (allowing theloading of sewing software) is installed in the control unit. The testsoftware offers no further functions. If the test software gets damagedduring the loading process, it is no longer possible to load a softwareusing a dongle.In such a case use a PC with a loader cable.Hint:The sewing unit is delivered with a machine software installed on it.CAUTION !Turn off the main switch before connecting the dongle.10.2 Loading the program– Turn the machine off at the main switch.– Insert the dongle 2 into the socket X110 (TEST-Interface) 1 of thecontrol unit (see pictures).– Switch on the main switch. The Software will be loaded. Theloading process takes less than 60 seconds.– During the loading process do not remove the dongle and do notswitch off the machine (otherwise you will damage the software) !– During this time, the version of the control panel will be displayed ,e.g. “BF1 C A 03" (blue screen).– When the loading process is finished, the program version will bedisplayed e.g. “745 A01”.– The new operating system must be confirmed via the “OK” key.Then the operating system will be started.– Remove the dongle 2 from the socket X110..– Confirm the software version by pressing the “OK” key.– The machine is ready for operation.Hint!Remove the dongle before re-starting the machine, otherwise it willload the sewing program again.After a replacement (first installation) of the DAC III control, the errormessage Error 9900 or Error 9901 or Error 9902 will be displayed afterloading the operating system.An initialization must first be carried out (see part 4 chapter 6)..2521 2

/ 30

Related manuals for DURKOPP ADLER 745-34-2