DURKOPP ADLER 906 Operating Instructions Manual

Also see for 906: Operating instructions Service manual Additional instructions

Contents

ProgrammingOperating Instructions 906 - 02.0 - 11/2016 77MP4 - Thread cuttingSymbol MeaningCutting speed(min. = 70 .. max. = 500; Def. =180 rpm)Speed of the cutting stitch.Cutting position on(min. = 0 .. max. = 359; Def. = 180 °)Angular position of the needle at which the thread cutting knife is switchedon.Cutting position off(min. = 0 .. max. = 359; Def. = 359 °)Angular position of the needle at which the thread cutting knife is switchedoff.Thread tension during thread cutting(min. = 0 .. max. = 100; Def. = 10 %)Thread tension of the cutting stitch.Position for thread tension during thread cutting(min. = 0 .. max. = 400; Def. = 370 °)Starting angle for the thread tension during the cutting stitch.(At an angle greater than 359 ° the thread tension is activated in the nextstitch.)MP5 - Clamping threadSymbol MeaningClose thread clamp at 1st stitch(min. = 0 .. max. = 250; Def. = 180 °)Start angle for closing the thread clamp during the first stitch.Open thread clamp at 1st stitch(min. = 0 .. max. = 359; Def. = 340 °)Starting angle for opening the thread clamp during the first stitch.If the closing and opening angles are the same then the thread clamp is notactivated.