2GENERAL SAFETY RULESWorking safely with this instrument is possible only when the operating and safety infor-mation are read completely and the instructions contained therein are strictly followed.The use of controls, adjustments, or the performance of procedures other than thosespecified herein may result in hazardous radiation exposure.DO NOT stare into the laser beams.DO NOT direct the laser beam at other persons.DO NOT disassemble the instrument or attempt to perform any internal servicing. Laserclass is indicated on the instrument. Repair and servicing of this laser are to be per-formed only by SitePro or authorized service centers.• When attaching the instrument to a tripod, make sure the instrument is securelyfixed. The tripod leg clamps should be securely fastened. If not securely fastenedor tightened, the main unit could fall off or the tripod could fall over.• The laser should not be stored or used in extreme temperature or during rapidtemperature change. The laser may not function properly if used out of the ambi-ent temperature range.• Store inside the carry case and place in a dry area not subject to vibration, dustor high moisture. If the storage temperature and ambient temperature for usagevary significantly, leave the laser in its case until it can adjust to the ambienttemperature.• The laser should be transported or carried carefully to avoid impact or vibration.• The laser should be stored in the carry case and packed with cushioning material.Always handle the laser with care.Site Pro, LLCus.com Made in Chinastare into the beam or view directly with optical instruments.ct. Complies with 21 CFR 1040.10 & 1040.11 except forLaser Notice 50, June 6, 2007e hacia el rayo. No mirar con instrumentos ópticos. Productomple con las normas 21 CFR 1040.10 y 1040.11, exceptonforme al Aviso para láseres 50, 6 de junio de 2007pas regarder le rayon. Ne pas regarder avec instruments .2M. Conforme à 21 CFR 1040.10 et 1040.11, sauf pourlaser 50, 24/6/2007IEC 60825-1:2007-03≤ 1 mW @ 630 - 670 nm2M