Da-Lite Tensioned Conference Electrol Instruction Book

Also see for Tensioned Conference Electrol: Specifications

Contents

Da-Lite Tensioned Conference Electrol Instruction Book Manual pdf 2 page image

2NOTE: Unit is not to be installed in air handling spaces.1. The case brackets provide multiple attachment points for bolts,cables, or threaded rod. The following page shows two locationsfor typical threaded rod installations with the external casemounting brackets (Figure 1a) and without them (Figure 1b). Theinternal case brackets can be accessed through the hand holes(Figure 1c).2. The case has a self-trimming flange around the bottom. Ceilingtiles or drywall may be placed on top of this flange to provide afinished appearance.3. After securing the case in the ceiling, check that the case is leveland plumb.4. Use supplied 1/8” nex key and a 1/4” wrench to remove silvershipping brackets attached to slat and screen case.5. Install electrical connections that apply to your unit. Refer to theelectrical diagram on page 4. The electrical connections areaccessible by removing the two screws on the primary junctionbox cover and the two screws on the secondary low voltagecover (Figure 2). You can remove the access door if needed toallow for greater access to the electrical wiring. To remove theaccess door; remove the screw from each end of the door whileholding the door and slide the door off the flanges (Figure 3).NOTE: Must be installed in accordance with the requirements ofthe Local Building Codes, the Canadian Electrical Code (CEC),CAN/CSA C22.1 and the National Electric Code (NEC), NFPA 70.InstallationImportant Safety InstructionsWhen using your video equipment, basic safety precautionsshould always be followed, including the following:1. Read and understand all instructions before using.2. To reduce the risk of electric shock, do not disassemble thisappliance. Contact an authorized service dealer when repairwork is required. Incorrect reassembly can cause electric shockwhen the appliance is used subsequently.3. The use of an accessory attachment not recommended by themanufacturer may cause a risk of fire, electric shock, or injury topersons.4. Do NOT lift or push up on the camera arm mechanism at anytime. This may cause improper operation and/or componentfailure or injury to persons.Pre-Installation1. Carefully unpack screen and remove outer wrapping from case.2. Make sure to recheck measurements of screen locationbefore installation.Hand HoleInternalBracketFigure 1a – Threaded Rod with Internal BracketFigure 1b – Threaded Rod with Internal and External BracketFigure 1c – Internal BracketHand HoleHand Hole