Dacor DDWF24S Installation Instructions Manual

Also see for DDWF24S: Use and care manual Installation instructions Planning guide Energy guide Planning guide

Contents

Dacor DDWF24S Installation Instructions Manual Manual pdf 11 page image

Level the DishwasherCAUTIONA level unit is Very important to pr0pe r operation. IBe sure to level the unit fron t t° back and side tOs de.The unit comes with white plastic feet for the legs toprotect the kitchen floor from being damaged whenyou slide the unit into place. They snap onto thebottom of all three legs. Install them before levelingthe appliance.Do not attach the plastic feet if the installation spaceis the minimum required height./ \To level the dishwasher:. Loosen the retaining nuts on the dishwasher'sthree steel feet using a crescent wrench. Turnthe nuts until they are as close to the floor aspossible.! \\ /2. Measure the height of the front and back of thecutout with a tape measure.3. Adjust the feet, until the front of the dishwashermeasures 1/8" (3 mm) shorter than the cutoutheight.4. Open the door and pull the bottom rack out of thedishwasher. Check to make sure the dishwasherfloor is level left to right using a level. Adjust thefront legs as necessary.5. Adjust the rear leg until the floor of thedishwasher is level front to back.6. Tighten the rear retaining nut, but leave the frontretaining nuts loose to allow for final leveling afterthe unit is pushed into place.Connecting the Electric CablePermanently Connected Appliance Only:If the cord is not long enough, or if a hard-wireinstallation is needed, follow the steps below tocomplete the electrical connection. Otherwise skipto Installing the Unit in the Cabinet. NOTE: Whendoing a hard-wire installation, you must remove thesupplied power cord.WARNING' Before starting this p[ocedure, be sure thepower is turned off at the breaker!fuse box., Make sure the water supply line, dra n line andoutside of the electrical cable do not touch anyexposed terminals of the dishwasher wiring.Remove the toe kick brackets from the front ofthe electrical access panel, below the door.ElectricalCatch access panel.3.Remove the electrical access panel.Disconnect the factory installed power cord fromthe terminal block and I_ground connection screwinside the access panel.Remove the cord. Terminal block locationContinued..._mCD_ 9