9Installation InstructionsInstalling the Oven in the CabinetWARNINGFailure to properly install the mounting screws may•result in movement or tipping of the oven during useresulting in personal injury.Do not block the oven air exhaust located at the bot-•tom of the oven. Blocking the intake may result in afire hazard, cabinet damage or poor performance.The wall oven is heavy. Do not attempt to install it in•the cabinet with less than two people.Do not use the exhaust grill or the bottom edge of•the oven opening as a gripping point. Damage to theexhaust grill may result.Lift the wall oven up to the cabinet cutout, using the1.upper edge of the cavity opening and the bottom of theoven case side as gripping points. Be certain to take allnecessary safety precautions due to the weight of theappliance.Resting the oven on the cabinet mounting platform,2.slide the oven into the recessed area until the rear edgeof the oven frame is flush with the cabinet face and theoven is centered within the cutout. Ensure that the elec-trical conduit slides through the opening in the cabinetplatform or coils above the oven chassis as the ovenis slid into place. The cable must be placed into therecessed area located along the rear vertical edge ofthe oven or coiled above the oven chassis. Do not trapthe appliance cable between the oven case back andthe rear wall.Locate the mounting holes in the trim on both sides of3.the oven.For single ovens there are 4 holes, 2 on each side.◊For double ovens there are 6 holes, 3 on each side.◊Use a 1/16” drill bit to drill pilot holes in the cabinet4.through all of the trim mounting holes.Install all of the provided #6 screws through the oven5.trim into the cabinet to secure the oven. Do not over-tighten the screws.GrippingpointDo notgrip here!Gripping point:case bottomboth sidesMounting Screw Locations