Dacor DO130 Installation Instructions Manual

Also see for DO130: Use and care manual Use and care manual Use and care manual Installation instructions Planning guide

Contents

Dacor DO130 Installation Instructions Manual Manual pdf 9 page image

Electrical ConnectionWARNINGIf the electrical service provided does not meet theElectrical Specifications (see page 4), do not pro-ceed with the installation. Call a licensed electrician tocorrectly install the required wiring.• Failure to disconnect power prior to installation mayresult in an electrical shock or fire hazard.• Do not turn on power to the appliance until the oven ispropedy grounded according to these instructions.• The installer must connect the ground terminal (orlead) on the appliance to a grounded, metallic, perma-nent wiring system or grounding conductor. Failure todo so may result in an electric shock hazard.° Do not install a fuse in the neutral or ground circuit. Afuse in the neutral or ground circuit may result in anelectric shock hazard.• The appliance must be connected to the power supplywith copper wire only. The use of aluminum wire mayresult in unsatisfactory conditions.IMPORTANT'Provide slack in the conduit to allow the oven to slidefo_ard for servicingl,The electrical connection leads from the suppliedappliance conduit may bea smaller gage than thestandard household wiring of the dedicated supply circuit They are suitable for c0nnection to househo!d wir.ing under the jurisdiction of the National Electric Code,and/or the local inspection authority.1. Before proceeding, turn off power to the junction box atthe circuit breaker panel or fuse box.2. Position the oven directly in front of the cabinet cutout.3. Feed the appliance conduit into the electrical junctionbox and attach it using a UL approved strain relief.4. Depending upon local codes, utilize one of three meth-ods to connect the appliance to the electrical power:¢ Connect to a 4-wire electrical system¢ Connect to a 3-wire electrical system with externalground, according to local codes.¢ Connect to a 3-wire electrical system, where localcodes permitConnecting to a 4-Wire Electrical System1. Separate the wires coming out of the appliance conduit.2. Connect the white wire from the appliance conduit tothe white (neutral) supply wire in the junction box.3. Connect the black wire from the appliance conduit tothe black (L1) supply wire in the junction box.4. Connect the red wire from the appliance conduit to thered (L2) supply wire in the junction box.5. Connect the green wire from the appliance conduit tothe green (ground) wire in the junction box.Junction boxREDI_REDGREEN_GREENIncomingpowerWHITEWHITEBLACKBLACK [_Wire nut,4 placesConduit toove n_mCD_ 7