9Warming Drawer Control Panel LayoutInstallation InstructionsVerify Warming DrawerOperation1. Connect power plug to the electrical outlet.2. Open the drawer and press the ON/OFF key on thecontrol panel.3. Press the PROOF, LOW, MED and HIGH keys eachin turn. When you press each key, the indicator directlyabove it should light. Leave the control panel set toHIGH.4. Press the SELECt key. The 1 HOUR indicator shouldlight. Press and release the SELECt key three (3)more times. Each time you press the SELECt key, the2 HOUR, 3 HOUR and 4 HOUR indicator lights shouldcome on. All lights should be on after pressing theSELECt key the third time.5. Press the "∞" key. The indicator light above itshould come on and the 1, 2 , 3 and 4 HOURlights should go out.6. The warming drawer should begin to heat.You should begin to feel the inside of thedrawer begin to heat within five (5) to ten (10)minutes.7. When you have determined that the heatingelement is working, press the ON/OFF key.If the warming drawer does not operate properly, followthese troubleshooting steps:• Verify that the circuit breaker for the electrical outletis on and not tripped. Make sure the power plug isconnected.• Repeat the above tests.• If the appliance still does not work, contact DacorDistinctive Service at (877) 337-3226. Do not attemptto repair the appliance yourself. Be sure to have themodel and serial numbers available when you call. Seepage 1 for model/serial number location.Dacor is not responsible for the cost of correcting problemsresulting from a faulty installation.Installation ChecklistWARNING• To ensure a safe and proper installation, the followingchecklist should be completed by the installer toensure that no part of the installation has beenoverlooked.• Proper installation is the responsibility of thehomeowner. The importance of proper installation ofyour warming drawer cannot be overemphasized.□ Support platform has been installed according to theinstructions on page 6.□ Properly grounded, dedicated, three prong electricaloutlet has been installed for the appliance by a licensedelectrician. See page 6.□ The chassis has been properly fastened to the supportplatform and sides of the cabinet.See page 7.□ The drawer has been properly installed. See page8.□ Model OWD24 for use as towel warmer: The towel rackhas been installed. See page 8.□ Proper operation has been verified?□ The warranty has been activated on-line or thewarranty card filled out completely and mailed?□ Save these instructions for future reference.