Dacor DYF42BNDI Installation Instructions Manual

Also see for DISCOVERY DYF42BNDI: Use & care manual Planning guide Use and care manual

Contents

Dacor DYF42BNDI Installation Instructions Manual Manual pdf 16 page image

14WARNINGTip Over HazardRefrigerator is top heavy and tips easily when notcompletely installed.Keep doors taped closed until refrigerator iscompletely installed.Use two or more people to move and installrefrigerator.Failure to do so can result in death or serious injury.3. Continue adjusting all of the leveling legs to raise therefrigerator until the top is within at least 1” (2.5 cm) of the topsoffit.NOTE: If an anti-tip board has been used, adjust the levelinglegs until the top of the refrigerator is within ¼” (6.4 mm) ofthe bottom of the anti-tip board as shown. Do not crush thecompressor cover.IMPORTANT: Adjust in small increments to keep fromdamaging the cabinet trim and causing problems with thedoor alignment or top grille fit. To avoid damage to the cabinetor leveling legs, do not apply more than 50 inch-pounds (5.7Nm) of torque to the leveling bolts. The leveling legs can beextended to a maximum of 1¼” (3.2 cm) below the rollers.Level and Align RefrigeratorIMPORTANT: All four leveling legs must contact the floor tosupport and stabilize the full weight of the refrigerator. The rollersare for moving the refrigerator and not for permanent support.After moving the refrigerator to its final location:1. Use a 5⁄16 ” socket driver to turn the leveling bolts clockwise toextend the legs to the floor as shown. The rollers should be offthe floor.2. Adjust the leveling legs to level and align the refrigerator fromleft to right and front to back so that the refrigerator is leveland aligned with the cabinetry. The cabinetry surface must beplumb for the ideal fit of the refrigerator side trim.Installation InstructionsA. Rear leveling boltB. Front leveling boltA B ABA. Center board 1/4” (6.4 mm) max. above refrigeratorB. Two 2” x 4” x 32” (5.1 cm x 10.2 cm x 81.3 cm) boardsC. Attach to studs with six #8 x 3” (7.6 cm) screwsD. Compressor cover2” (5.1 cm)A BCD