Dacor Distinctive DTO127 Installation Instructions Manual

Also see for Distinctive DTO127: Use and care guide Use and care manual Installation instructions Use and care manual

Contents

Dacor Distinctive DTO127 Installation Instructions Manual Manual pdf 8 page image

6Installation SpecificationsInstallation PlanningWARNINGObserve all governing codes and ordinances during plan-ning and installation. Contact your local building depart-ment for further information.IMPORTANT• Locate the junction box so that the oven may be easilydisconnected in the event that it needs to be removedfrom the wall completely for service.• If the oven is not installed level it may deliver poor orinconsistent baking results.• Carefully check the location where the oven is to beinstalled. The oven should be placed for convenientaccess. Make certain that electrical power, meeting thespecifications on page 4, can be provided in theselected location.• Dacor recommends installing the junction box in theone of the locations shown on the facing page.Minimum interior cabinet depth: 24” (61.0 cm)• Install the junction box in a location that allows theoven to be removed from the cutout for service withoutbeing disconnected.• Plan the installation so that all minimum clearancesare met or exceeded. Dimensions shown provide mini-mum clearances, unless otherwise noted. Be certainthat proper clearance is provided for the oven doorwhen it is in the open position according the ProductDimensions.• Cabinet cutout dimensions must be used as indicated.The specified minimum cabinet depth and width mustbe provided. The cabinet depth and width must com-pletely enclose the recessed portion of the oven.• All contact surfaces between the appliance and thecabinet must be solid and level.• Provide a platform within the cabinet to support theoven. It must be installed level and straight. The topedge of the platform must be flush with the cutout atthe front of the cabinet. There are no provisions to levelthe oven after it has been installed. 3/4” (1.9 cm) thickplywood is recommended.ModelNumber(N) MinimumCabinet Width (P) Cutout Width (R) Cutout HeightDTO(V)127 27” (68.6 cm)25 1/2” (64.8 cm)minimum (recommended)26 1/8” (66.4 cm)maximum26 3/4” (67.9 cm)minimum (recommended)27 1/2” (69.9 cm)maximumDTO(V)130 30” (76.2 cm)28 1/2” (72.4 cm)minimum (recommended)29 1/8” (74.0 cm)maximum26 3/4” (67.9 cm)minimum (recommended)27 1/2” (69.9 cm)maximumDTO(V)227 27” (68.6 cm)25 1/2” (64.8 cm)minimum (recommended)26 1/8” (66.4 cm)maximum49 1/8” (124.8 cm)minimum (recommended)50” (127.0 cm)maximumDTO(V)230 30” (76.2 cm)28 1/2” (72.4 cm)minimum (recommended)29 1/8” (74.0 cm)maximum49 1/8” (124.8 cm)minimum (recommended)50” (127.0 cm)maximumCabinet Dimensions Cabinet tolerances: +1/16 (1.6 mm), -0, unless otherwise stated.