Dacor ECS136SCH Installation Instructions Manual

Contents

Dacor ECS136SCH Installation Instructions Manual Manual pdf 6 page image

VERIFYING THE PACKAGE CONTENTSVerify that all required components have been provided. Ifany item is missing or damaged, please contact your dealerimmediately. Do not install a damaged or incomplete appliance.• Mounting Screws• Use and Care Videotape• Oven Racks• Broiler Grill and Pan• Exhaust Grill/Lower Trim• Rear Top Trim• GlideRack TM Oven Rack• Light Lens Pry StickiNSTALLATION PLANNINGA qualified technician must complete the installation of this built-inappliance. Proper installation is your responsibility.Carefully check the location where the oven is to be installed. Theoven should be placed for convenient access. Make certain thatelectrical power can be provided in the selected location.Plan the installation so that all minimum clearances are met orexceeded. Dimensions shown provide minimum clearances,unless otherwise noted. Be certain that proper clearance isprovided for the oven door when it is in the open position.The specified minimum cabinet depth and width must be provided.The cabinet depth and width must completely enclose therecessed portion of the oven.Cabinet cutout dimensions must be used as indicated. All contactsurfaces between the appliance and the cabinet must be solid andlevel. The oven support platform must be flush with the bottomedge of the cabinet cutout.Make certain that you have everything necessary to ensure aproper installation before proceeding.INSTALLING THE SUPPORT PLATFORM INTHE CABINETProvide a platform within the cabinet upon which the oven will besupported. The platform must be installed level and straight. Thetop edge of the platform must be flush with the cutout at the frontof the cabinet. There are no provisions to level the oven after ithas been installed. 3/4" (19mm) thick plywood is recommended.NOTE:An oven that is not level may provide poor or inconsistentbaking results.ELECTRICAL POWER SUPPLYREQUIREMENTSIt is the owner's responsibility to ensure that a qualified electricianperforms the electrical connection of this appliance. The electricalinstallation, including minimum supply wire size, must comply withthe National Electric Code ANSI/NFPA 70-1990" (or to the latestrevision) and local codes and ordinances.*A copy of this standard may be obtained from:National Fire Protection Association1 Batterymarch ParkQuincy, Massachusetts 02269-9101The correct voltage, frequency, and amperage must be suppliedto the appliance from a separate, grounded, single phase circuitthat is protected by a properly sized circuit breaker or time-delayfuse. If a time-delay fuse is utilized, fuse both sides of the line (L1and L2).The required voltage, frequency and amperage ratings are listedon the product data plate (located inside the intake grill to the leftof the door latch) and in the Table below.The correct voltage, frequency, and amperage must be suppliedto the appliance from a separate, grounded, single phase circuitthat is protected by a properly sized circuit breaker or time-delayfuse. If a time-delay fuse is utilized, fuse both sides of the line (L1and L2).The required voltage, frequency and amperage ratings are listedon the product name plate (located inside the intake grill to the leftof the door latch) and in the Table below.NOTES:1. Preheat times and cavity temperature recoverytimes will be increased slightly if operating on a120/208 volt power supply.2. 208V models should not be connected to 240Vsource power.3. Power supply must be an isolated circuit.dacar 5