4Installation InstructionsBefore OperationNOTE: Dacor recommends cleaning the appliance according tothe cleaning instructions in the use and care manual before use.IMPORTANT:Read the use and care manual completely before operation.◊The importance of the proper installation of your Dacor◊built-In appliance cannot be overemphasized. To ensure asafe and proper installation, the following checklist shouldbe completed by the installer to ensure that no part of theinstallation has been overlooked.Installation ChecklistHas the appliance been secured in place in the countertop or□ cabinet?Are all leveling legs extended down to make contact with the□ floor? Is the unit level?Is the power cord plugged into a properly grounded dedicated□ three prong electrical outlet, which has been installed inaccordance with all applicable electrical codes?Has the warranty been activated on-line or the warranty card□ been filled out completely and mailed?Once the power cord is connected and the unit is turned on,the appliance will take several hours to cool down. Load thecompartment once it is cool. See the use and care manual forfurther instructions.If the appliance does not work after performing the abovechecklist, contact Dacor Distinctive Service at (877) 337-3226. Donot attempt to repair the appliance yourself.Dacor is not responsible for the cost of correcting problemscaused by a faulty installation.Handle InstallationInsert the end caps into1.the center portion of thehandle.Thread the included set2.screws two turns intothe handle end caps.End capsSet screwsPut both ends of the3.handle over the handlemounting pins on therefrigerator.Tighten both set screws4.into place using theincluded Allen wrench.Do not overtighten.