Dacor EF36IWF Use And Care Manual

Also see for Epicure EF36IWFSS: Instruction sheet

Contents

Dacor EF36IWF Use And Care Manual Manual pdf 5 page image

3Temperature ControlsFor your convenience, your temperature controls are preset atthe factory. When you first install your refrigerator, make sure thecontrols are still set to the recommended set points. Press the touch pad next to “FRESH FOOD TEMP” on themain menu to display the current set point of the compartment.Press the touch pad next to “WARMER” or “COLDER” toadjust the set point to the recommended 38°F. Press the touchpad next to “Done” to lock in the setting. Press the touch pad next to “FREEZER TEMP” on the mainmenu to display the current set point of the compartment.Press the touch pad next to “WARMER” or “COLDER” toadjust the set point to the recommended 0°F. Press the touchpad next to “Done” to lock in the setting.To Adjust Set Point Temperatures:If you need to adjust the temperature in either the refrigeratoror freezer compartment, use the settings listed in the chart asa guide. The display will show the set point for approximately 3seconds. Press the touch pad next to “WARMER” or “COLDER” toadjust the set point to the desired temperature. Then, pressthe touch pad next to “Done” to lock in the new set pointtemperature.NOTE: Except when first turning on the refrigerator, do notadjust either temperature control more than one setting at atime. Wait 24 hours for the temperature to stabilize betweenadjustments.CONDITION/REASON: ADJUSTMENT:REFRIGERATOR too warm FRESH FOOD Control1° lowerFREEZER too warm/too little ice FREEZER Control1° lowerREFRIGERATOR too cold FRESH FOOD Control1° higherFREEZER too cold FREEZER Control1° higherSetting the ControlsThe control panel is located on the front of the ice and waterdispenser.To access the main control menu, press any of the four touchpads located on either side of the display. Then, touch the padnext to the desired option or user setting to access the variousfeatures.IMPORTANT: Press only the touch pads next to your selection on the displayscreen, not the selection itself. Wait 24 hours for your refrigerator to cool completely beforeadding food. If you add food before the refrigerator has cooledcompletely, your food may spoil. Adjusting the refrigerator and freezer temperature controls toa colder than recommended setting will not cool the compart-ments any faster. The recommended settings should be correct for normalhousehold refrigerator use. The controls are set correctly whenmilk or juice is as cold as you like and when ice cream is firm. If the temperature is too warm or too cold in the refrigeratoror freezer, first check the air vents to be sure they are notblocked before adjusting the controls.Turning Cooling On or OffCOOLING OFF controls all cooling functions, the control paneland the dispenser. It does not disconnect power to the refrig-erator. Press and hold the COOLING OFF touch padfor three seconds. The LED will light up toindicate that cooling is off. Neither compartmentwill cool. Press the COOLING OFF touch pad again toturn on the cooling. The LED will turn off.NOTE: At times, the front of the refrigerator cabinetmay be warm to the touch. This condition is normaland helps prevent moisture from condensing on the cabinet. Thiscondition will be more noticeable when the refrigerator is firststarted, during hot weather and after excessive or lengthy dooropenings.Refrigerator OperationCOOLINGLOCKEDAUTODISPENSEWATERONPRESS 3 SECPRESS 3 SECOFFCOOLINGLOCKEDDISPENSEWATERPRESS 3 SECPRESS 3 SECOFFControl PanelDisplay touch pads