Dacor ERV30 Installation Instructions Manual

Also see for ERV30: Planning guide Planning guide Installation instructions Planning guide Combination installations

Contents

Dacor ERV30 Installation Instructions Manual Manual pdf 10 page image

8Cut and remove the foil material inside the knock-out2.hole. If you fail to remove the foil, the vent will not work.If the unit will vent through the bottom or side:3.Attach the supplied ATD2 transition to exhaust•location with the provided sheet metal screws.For bottom installations cut a hole in the cabinet•floor to allow the exhaust transition and/or the ductto pass through the floor.If the unit will exhaust air from the back, attach a4.3 1/4” X 10 duct to the vent hole created by removingthe knock-out on the back of the unit.Installation InstructionsADT2 sideinstallationADT2 bottominstallation Attach sealingfoamADT2 Transition InstallationFloorCut hole in floor to allowduct to pass through onbottom venting installationsTop of vent restingon countertopInstallation PreparationVerify Package ContentsProduct literature•Anchoring legs•2 wood screws, #14 x 2 1/2 (PN 83047)•3 wire nuts•ADT2 duct transition•2 sheet metal screws, #10 x 1/2 (PN 83022)•2 keps nuts, 1/4-20 (PN 83049)•2 flat washers, 1/4-20 (PN 83203)•Insulation foam•InstallationWARNINGIf the electrical service (electrical outlet) does not•meet the Electrical Specifications on page 4, do notproceed with the installation. Call a licensed electri-cian and have an electrical outlet installed that meetsthe specifications.Install the vent only in a vertical orientation. Do not•mount the vent on a slant or angle.Do not enlarge or modify the exhaust knock outs or•cut an exhaust hole in a location on the chassis otherthan those shown. Doing so may cause an increasein noise and decrease performance.NOTE: The ERV series raised vent installs in the back ofthe cutout, separate from the range. Install the raised ventbefore pushing the range into place.Installing the Raised VentRemove the appropriate side, back or bottom exhaust1.knockout, depending on the desired exhaust configura-tion, from the raised vent chassis by cutting the metalcross overs and removing the insert.Sideknock-outSideknock-outBottom knock-outRear knock-out withmetal cross oversshownVent Knock-out Locations - Rear ViewBack of unit