Dacor Epicure ED30 Installation Instructions Manual

Also see for Epicure ED30: Use and care manual Planning guide Use and care manual Installation instructions Installation instructions

Contents

Dacor Epicure ED30 Installation Instructions Manual Manual pdf 9 page image

7Installing the Unit in the CabinetCare should be exercised when the appliance is installed orremoved, to reduce the likelihood of damage to the powercord or hoses.With the assistance of at least one person, set the unit1.in front of the cut-out opening.Feed the electrical cord, drain hose and water supply2.hose through the utility access hole(s) in the side(s) ofthe cabinet.Slide the dishwasher back into the opening while3.pulling the hoses and electric cord through the utilitycutouts in the cabinet from the back. Stop when thedishwasher contacts the back wall or aligns with thefront cabinet opening.Leveling the DishwasherCAUtIONA level unit is very important to proper operation. Be•sure to level the unit front to back and side to side.Do not use a power driver to adjust the rear leveling•legs, doing so may damage the dishwasher.Do not over torque the leveling legs. Doing so•will distort the dishwasher chassis leading to dooralignment problems and possible water damage.To prevent damaging the dishwasher, adjust the•leveling legs only 1/2” (13 mm) at a time, per leg.To align the dishwasher correctly inside the cabinetopening, the legs must be adjusted to level the appliance.After centering the appliance in the opening, level theappliance by adjusting all four leveling legs.To verify front to back level, remove the lower rack from1.the dishwasher and place a level on the tank side wallrack guides.To verify left to right level, place a level on the tank2.lower front frame.Continued...WARNINGDo not connect the electrical, water inlet or drain•until instructed to do so in the Verifying ProperOperation section.Do not install the dishwasher unless the•electrical service provided meets the ElectricalSpecifications.A qualified technician must complete the installation•of this built-in appliance. The owner is responsible tomake sure the dishwasher is properly installed.To avoid an electrical shock hazard, make sure•the dishwasher power plug is disconnected beforeproceeding with the installation.Do not allow any material, including the hoses or•electrical wiring to be directly behind the dishwasherwhile pushing it into the cut-out opening. Carefullypull the slack out of both hoses and the wire fromoutside the cut-out during push back to preventpinching. An electric shock hazard or water damagemay result from pinched wires or hoses. Damage dueto improper installation is not covered under warranty.Keep the factory installed high loop drain hose in•place to ensure proper dishwasher operation. Do notcut, tie, strap or lower it. If it is necessary to lengthenit, install an aftermarket drain extension kit, availableat most home improvement stores.Installation InstructionsDrain hoseHIGH LOOP DRAIN HOSEUtility cutoutsHoses andpower cord