Dacor Epicure ER30G Installation Instructions Manual

Also see for Epicure ER30G: Instruction manual Instructions Use and care manual Installation instructions Planning guide

Contents

Dacor Epicure ER30G Installation Instructions Manual Manual pdf 12 page image

10Installation InstructionsGas ConnectionWARNINGMake sure the gas is turned off at the gas supply•valve before connecting the gas line.Verify that the gas supply meets specifications before•connection. See page 4.Do not apply excessive pressure when tightening gas•connections and fittings.Do not use Teflon tape or plumber’s putty on flexible•gas line connections.Test the gas lines for leaks as instructed before use.•If a leak is detected, open all doors and windows andallow the gas to dissipate before fixing the leak andtesting the unit.Do not use a flame to check for leaks.•The maximum gas supply pressure to the regulator•must never exceed ½ pounds per square inch (psi) or3.5 kPa.The range and shut-off valve must be disconnected•from the gas supply piping system during anypressure testing exceeding ½ psi (3.5 kPa).The range must be isolated from the gas supply•piping system by closing the shut-off valve to thecooktop during any gas supply piping systempressure testing equal to or less than ½ psi (3.5 kPa).For LP gas installations, the LP gas tank must have•its own high-pressure regulator in addition to thepressure regulator installed on the range.IMPORTANT: The installed gas pressure regulator is pre-set at the factory for the type of gas intended for use withthe appliance. Verify that the appliance is compatible withthe type of gas available by checking the product data labelattached to the appliance. Ranges intended for use withLP gases will have “LP” as a part of the model number.Consult your dealer if the range is not compatible with yourgas supply.Make sure the gas supply valve is in the off position1.and the range power cord is disconnected.Connect a flexible gas supply line to the gas shut-off2.valve previously installed on the stub out. The gasline needs to be long enough to allow the range to bepulled out for service.Connect the gas line to the regulator on the back of the3.range.Turn all cooktop control valves to the4.“OFF” position.Turn on the gas supply valve and check5.all lines and connections for leaks using asoap and water solution or an electronicgas leak detector.Turn the gas supply off.6.Gas Line Connection“OFF”symbol onknobAnti-tip foot1/16” off floor1/2” male NPTconnection