Dacor Epicure ER30GSCH Installation Instructions Manual

Also see for Epicure ER30G: Instruction manual Instructions Use and care manual Installation instructions Planning guide

Contents

Dacor Epicure ER30GSCH Installation Instructions Manual Manual pdf 5 page image

3Important Safety InstructionsInstallation SpecificationsProduct DimensionsFor your safety, do not use the oven to cook without the convection filter installed. When the filter is not installed,•the spinning fan blades at the back of the oven are exposed.The cooktop should never be operated without the knobs and trim rings in place.•Non-stick coatings, when heated, can be harmful to birds. Remove birds to a separate, well-ventilated room during•cooking.Always ensure that the light fixture lens cover is in place when using the oven. The lens cover protects the light bulb•from breakage caused by high oven temperatures or mechanical shock.IMPORTANT - This appliance is equipped with a three-prong grounding plugfor your protection against possible electric shock hazards. Plug it only into adedicated, grounded three-prong electrical outlet. It is the responsibility of thecustomer to make sure the proper type of outlet is installed. Do not under anycircumstances:Cut or remove the third (ground) prong from the power cord.•Use an adapter plug.•Use an extension cord.•Use a power cord that is frayed or damaged.•Connect to an electrical outlet with a ground fault interrupter (GFI).•WARNING1 1/8” (29mm)1 9/16”(40mm)2” (51mm)3” (76mm)Front of open doorFront of handleFront edge of bullnoseFront panelRear of front panelBackguard thickness26 1/8” (664mm)27 1/16” (687mm)28 9/16” (725mm)24” (610mm)3” (76mm)Backguard***ER30G:Full stainlesssteel side panelsER30GI:Partial stainlesssteel side panelGrates extend1” above trim 6” (152mm)Backguard*1 3/4” (44mm) Backguard********Optional on both models, NOTcompatible with self-rimming installationsStandard on model ER30GOptional on model ER30GI, NOTcompatible with self-rimming installationsStandard on model ER30GIOptional on model ER30GProduct width:29 7/8” (759mm)ER30G is designed for freestanding install-ations. ER30GI is designed for installationin a recessed cabinet or island. ER30G isNOT equipped for self-rimming installation.NOTE: Neither model iscompatible with a raised vent.35”(889mm)to37 1/8”(943mm)9” (229mm)Backguard***45 9/16” (1157mm)All tolerances: ±1/16” (±1.6mm), unless otherwise statedOverall Dimensions