Dacor Epicure OB36 Installation Instructions Manual

Also see for Epicure OB36: Use and care manual Use & care manual Planning guide Use and care manual Installation instructions

Contents

Dacor Epicure OB36 Installation Instructions Manual Manual pdf 9 page image

7Planning the InstallationLocation Planning - EnclosedCabinetsMaintain all minimum clearances specified on pages 7•and 8.For proper outdoor grill operation, provide a flat, level•mounting surface with minimum 3/4” thickness.All models are designed to allow installation in combus-•tible or non-combustible base material structures.On installations without a LP cylinder tank located•below the unit, plan the installation so that the gasshut-off valve and pressure regulator are accessibleafter the appliance is installed so that gas and powercan be turned off if service is required. Also, make surethe electric plug can be disconnected easily during ser-vice.Optional Finish Trim KitsThe optional finish trim can be installed on the countertopto finish the sides and back of the countertop opening. Thestainless steel finish trim can be caulked to the countertopand should be secured to the base enclosure with flat headscrews. Center the trim within the cutout dimensions notedin this manual, then utilizing the deck screws along withthe holes located along the vertical sides of the finish trim,install them securely to the base enclosure countertop sub-straight. Optional Finish Trim Kits.Enclosed Cabinet Installations with a LPCylinderWhen using a LP-gas cylinder, it must be completely•enclosed, It must also be ventilated by openings onthe sides, back and floor of the enclosure. Each open-ing must have a total area of no less than 10 squareinches (254 square mm).Plan to install the grill in a base structure that has one•of the following structural details:The LP cylinder valve shall be readily accessible◊for hand operation. A door on the enclosure to gainaccess to the cylinder valves is acceptable, pro-vided it is non-locking and can be opened withoutthe use of tools.The enclosure for the LP-gas cylinder shall isolate◊the cylinder from the burner compartment to pro-vide shielding from radiation, a flame barrier andprotection from foreign materials such as hot drip-pings.There shall be a minimum clearance of 2 inches◊(51mm) between the floor of the LP-gas cylinderenclosure and the ground.The design of the outdoor cooking enclosure must•allow the LP-gas cylinder to be connected, disconnect-ed and the connections inspected and tested outsidethe cylinder enclosure.Connections which may be disturbed when installing•the cylinder in the enclosure can be leak tested insidethe enclosure.Internal mounting means shall be provided on the out-•door gas grill for mounting the LP-gas supply cylinder.If the outdoor grill is not in use, the gas must be turnedoff at the supply cylinder.Rotisserie mountingbracket (factory installed)JunctionBoxTrim frame(accessory)3/4" (19mm)min. to anymaterial*1/4"(6mm)1 1/4"(32mm)10" (254mm) Min. to combustibles1 1/4" (32mm) Min. to non-combustible28 1/2" (724mm)To finishedcountertop23 3/4" (603mm)24" (610mm)JunctionBoxTrim frame(accessory)3/4" (19mm)Min. to anymaterial*10" (254mm) Min. to combustibles2" (51mm) Min. to non-combustible1/4"(6mm)23 3/4" (603mm)24" (610mm)See page 8 for overall cabinet dimensionsSee page 8 for overall cabinet dimensionsoB36, oBs36, oB52 and oBs52cutout dimensions - Side ViewoBSB162 cutout dimensions -side view