IntroductIon Custom decorator panels cover the door trim of Dacor IF36 series refrigerators for an attractiveseamless look that flows into the overall design of the room. Fabricate the panels first, then slidethem into the door trim frames. The panels are custom designed and installed by your cabinetmaker. Installation may be accomplished using various methods. Below are three examples.For additional installation ideas, see the 3-Door Custom Overlay Installation Guide (PN 102426).Three Panel MethodThe backing panel (1/4” [6 mm] thick) slides behind the trim frames that surround the edges ofeach door. The spacer (1/8” [3 mm] thick) compensates for the thickness of the trim frame. Thedecorative front panels (3/4” [19 mm] thick maximum) are designed to match the surroundingcabinets and cover the trim frame around the edges of the door. Countersink the screws used toassemble the panels.WARNING: Individual door panels must not exceed the maximum weight specifications.CUSTOM OVERLAY PANEL INSTALLATIONINSTRUCTIONSREFRIGERATOR MODELS: IF36BNDFSF, IF36INDFSFPart No. 100504 Rev. FRouted Raised Panel MethodCreate a routed raised panel and screw or glue the front panel directly to the 1/4” thick backingpanel. Instead of using a spacer panel, route the edges of the front panel to compensate for thetrim frame thickness. For the top two doors on three door models, do not route the inner edgesbecause there are no trim frames in the center where the doors come together. Countersink thescrews used to assemble the panels.Spacer Panel (1/8”)Refrigerator DoorFront Panel (3/4” Max.)Backing Panel (1/4”)Trim FrameSurrounding DoorBacking Panel (1/4”)Refrigerator DoorFront Panel (7/8” Max.)Routed Area(1/4” W X 1/8” D)Trim FrameSurrounding DoorSingle Panel MethodA single 1/4” panel design can be created using the trimframes to frame the panel (the trim frames will be exposed).Single 1/4” PanelTrim Frame Surrounding DoorRefrigerator Door