PLANNINGGUIDEwww.Dacor.com Phone: (800) 793-0093All specifications subject to change without notice.Install all appliances according to accompanying installation instructions. CI.12StiffenerCabinet faceCountertopFloor3/8” Min. (10 mm) spacebehind raised ventchassis to clear stiffener3/8” Min. (10 mm)flat countertop overhangrequired behind cutoutERV or PRV series raisedvent: Check raised ventdimensions/specificationsto determine proper fitSGM Series CooktoprGC/sGm series Drop-In Gas Cooktopwith Erv/Prv series raised ventCombINATIoN INsTALLATIoNsDocument # PGCI-008 Revised 05/07/09 Page 1/2WARNINGObserve all governing codes and ordinances during•planning and installation. Contact your local buildingdepartment for further information.All appliances must be installed in accordance with the•accompanying installation instructions.All tolerances +1/16” -0 (+1.6 mm, 0) unless otherwise notedCutout DimensionsSide View - RGC/SGM Series Cooktop withERV/PRV Series Raised VentIMPORTANT: Be careful to use the correct cutout diagram (on page 2/2) to determine the countertop dimensions. Carefully double checkall dimensions against the table below and the correct diagram before cutting the countertop.* Total cutout depth, accommodates both the cooktop and raised vent** IMPORTANT: Notch depth is included in total cutout depth (D). DO NOT add notch depth to total cutout depth (D).RGC or SGM series cooktopCountertop DimensionsInstallation Type CutoutDiagram C (minimum) D E F G HRGC/SGM304 withERV30 or PRV30Figure 1(Square)3/8”(10 mm)22 1/2” *(572 mm)27 3/4”(686 mm) NA NA NARGC/SGM365 withERV36 or PRV36Figure 1(Square)3/8”(10 mm)22 1/2” *(572 mm)33 5/8”(854 mm) NA NA NARGC/SGM466 withPRV46Figure 2(Notched)3/8”(10 mm)22 1/2” *(572 mm)44 3/4”(1137 mm)43 1/2”(1105 mm)5/8”(16 mm)2 5/8” **(67 mm)