6Part Qty ExampleHood (modelsvary in size/appearance)1Grease channel 1Baffle-style filterw/knobs (ready-to-assemble kit)48” (4)36” (3)30” (2)Holding brackets,hardware 2Dimmable LEDlight bulbs48” (4)36” (3)30” (2)Light-replacement tool 1Product literature(Installation, Use-and-Care guides)2Dacor cleaningcream 1 STAINLESSSTEELCLEANERPreparation and SetupParts ListHave these tools and hardware within reach before youstart the installation.Blower Rotation (option)Phillips screwdriver 5/16” Nut driverDual-to-Single Vent Transition Kit (option)Dacor Kit #AHT10 Sheet-metal screws10” Ducts, ducting material Foil tapeDrill, bitsNeeded Tools/HardwareHood InstallationPhillips screwdriver LevelFlathead screwdriver Junction boxPencil/marking tool JigsawWire connector caps 8” DuctingWire stripper Foil tapeDrill, bits Sheet-metal screwsWARNINGMake sure a licensed electrician installs the electricalservice to the range hood.• The owner is responsible for verifying that all electricalrequirements are met by the qualified electrician servicingthis appliance.• The electrical installation (incl. the minimum supply-wire size and grounding) must comply with the NationalElectric code ANSI/NFPA (or latest revision), localcodes, and ordinances. Obtain a copy of the ANSI/NFPAstandard from:National Fire Protection Association1 Batterymarch ParkQuincy, Massachusetts 02269-9101• The ground terminal on the hood must be connectedto a grounded, metallic, permanent wiring system, or agrounding conductor installed by a licensed electrician.• Do not ground the appliance or appliance wiring to a gaspipeline or to the neutral (white) power supply wire.• Do not install a fuse in the neutral or ground circuit.• Connect the hood directly to an electrical junctionbox. Hard-wire the hood according to local code directlyto a dedicated three-wire grounded, single phase circuitrated at 120 Vac 60 Hz, 15 Amp.Meeting Electrical Codes