Dacor RV30 Installation Instructions Manual

Also see for RV30: Planning guide Use and care manual Installation instructions Use and care manual Planning guide

Contents

Dacor RV30 Installation Instructions Manual Manual pdf 6 page image

5Blower InstallationWARNING:Do not slide the CABP3 blowerover or beyond the mountingstop on the blower mountinggroove. To do so may preventthe vent sleeve from raising and/or lowering due to interferencebetween the blower and the ventdrive arm assembly.Connecting the Exhaust DuctNOTE:Use duct tape to seal theconnection between the bloweroutlet and duct. Support the ductweight as necessary to ensuresealed joints.For the side or bottom knockouts use the sup-plied transition (ATD2). For the rear knockoutattach a 3 1/4" x 10" duct.Electrical ConnectionWARNINGS:1. Ensure that the power supplyis disconnected beforeproceeding.2. Verify that the power supplymatches the ratings found onthe appliance data plate beforeproceeding.3. The complete appliance mustbe properly grounded at alltimes when electrical power isapplied.4. Do not ground the appliancewith the neutral (white) housesupply wire. A separateground wire must be utilized.5. If aluminum house supplywiring is used, splice theappliance copper wires to thealuminum house wiring withspecial connectors designedand agency-certified for thispurpose. Follow the connectormanufacturer’s recommendedprocedure carefully. Improperconnection can result in a firehazard.N1L1N2BLKWHT120VAC, 60Hz, 15ASupply power fromdedicated circuit breakerGRNWHTL2 BLKBLKWHTGnd GRNGnd GRNRVL2N2GndGRNWHTBLKL2N2Gnd GRNWHTBLKGRNWHTBLKILBREMP OR CABP3J-BOXWiring of RV with ILB and REMP or CABP3Installing the Raised VentLoosely attach the support legs to the left andright sides of the plenum using the hex nutsprovided. Place the vent into the rear of thecountertop cutout. Adjust the support leg heightso that the end caps are gently resting on thecounter, then tighten the hex nuts. Secure thesupport legs to the cabinet floor with the screwsprovided.For the cabinet blower application, place theadhesive-backed foam tape provided with thecabinet blower onto the left and right verticalblower flanges. Slide the blower outlet into theexhaust duct, while making sure that the lowerblower flange slides into the blower mountinggroove on the vent. Use duct tape to seal theconnection between the blower outlet and theduct. Support the duct weight as necessary toensure sealed joints.For downdraft vents utilizing the remote blowers,locate the AREM found in the RV carton. Attachthe adhesive-backed foam tape provided withthe blower to the left and right vertical blowercover flanges. Attach the Remote Blower Cover(AREM) to the large opening in the front of thevent. The vent is now ready to be ducted for aremote blower installation.NOTE:For both the cabinet and remotesystems, the vent must beinstalled in a vertical orientation.Do not mount the vent on a slantor angle.6. Failure to complete electricalconnections properly mayresult in a damaged or non-functional system. Follow thewiring diagrams carefully toensure a proper installation.Both vent systems require a properly grounded,120 VAC, 60 Hz., 15 Amp electrical service.Max. full line load is 8 amps. Always use adedicated circuit. Do not use same circuit thatcooktop is using.Make all electrical connections between the ventand blowers, then connect power to the vent asper the wiring diagrams shown on pages 5 and6. Use wire nuts provided and electrical tape tosecure all wiring connections at the blowers.