4Cleaning the FiltersClean the filters and surrounding areas regularly to pre-vent grease build-up.the Clean FIlter key indicator light willilluminate after 40 hours of blower use toremind you to clean the filters (push theClean FIlter key to reset). The filtersmay need to be cleaned more often basedupon the type and amount of cooking.Check the filters regularly.to clean the filters:Raise the vent to the “up” position to clean the filters.•remove the grill as described in the• Grill Cleaningsection.The filters are positioned side by side inside the vent•intake. When properly installed, the tops of the filterslean against the rear intake panel and the filter bot-toms rest in a slot attached to the front intake panel.Remove one filter at a time by gently grasping the topcenter of the filter and lifting it up and out.Clean the filters by hand washing them in hot water•with a mild detergent solution. clean the intake panelalso (see following page).Make sure the filters are dry before carefully reinstall-•ing them.reinstall the intake grill.•Grill Cleaningsecure the keypad (see facing page).•remove the grill with the vent in the raised position.•gently grasp the grill on both ends. Lift it up, thenrotate the bottom of the grill out of the lower groove.clean it regularly. hand wash it in hot water with amild detergent solution. Set the grill on a flat surfaceand wipe only in the direction of the grill grain.Do not use any cleaners containing ammonia as this•will damage the anodized aluminum finish. A softtoothbrush or nylon bristle dish brush may be used toclean the grill grooves.after cleaning, reinstall the grill. align the left and•right edges of the grill with the vertical grill guidesand insert the upper edge of the grill into the slot inthe top cap. pivot and drop the bottom of the grill intothe lower locating slot.warningclean the vent only in the manner specified.•to avoid dangerous fumes or damage to your vent’s surfaces, use only the types of cleaning solutions specified in•this manual.to avoid personal injury, turn off the range and vent and make sure all surrounding surfaces are cool before•cleaning.always wipe stainless steel (silver colored) surfaces with the grain. to prevent scratching, do not use abrasive•cleaners or scrubbers on stainless steel surfaces.to avoid damage to the fan, do not reinstall damaged filters.•to avoid damage, do not clean the filters in a dishwasher.•Care and CleaningCleanFIlterremoving the GrillLift here Lift hereslide bottom outtop capraised ventside viewrear intake panelGrasp filter and liftfront intake panellocation of mounting Groovegrill mount groovevertical grill guide(left shown)