17Installation InstructionsVerifying Proper Operation1. Remove any packaging from inside the oven.2. Slide the oven racks onto the supports inside the ovenchamber according to the use and care manual.3. Prior to operating the range, please read the accompanyinguse and care manual carefully. Important safety, service andwarranty information are contained within.4. Turn on power to the range at the circuit breaker panel orfuse box.5. Set the clock according to the use and care manual.6. Press the BAKE key on the control panel. The default baketemperature should appear on the display.7. Press START. After approximately three (3) minutes, check tomake sure the oven is heating.8. Press CANCEL SECURE.9. Place a pot 1/4 full with water on one of the cookingelements. Match the size of the pot to the size of the cookingelement. NOTE: You must use a pot that attracts a magneton the pan bottom to test operation.10. Hold your finger on the ON/OFF key for one second toactivate the control (the diagram next to the ON/OFF keydetermines the correct control). “0” will flash on the display.11. Touch the HIgH key.12. Once the pot begins to heat, touch LOw, then MED. Verifythat the power level changes.13. Touch the power level up key (▲). Verify that the power levelgoes up.14. Touch down (▼). Verify that the power level goes down.15. Touch ON/OFF to turn off the cooktop.16. If either the oven or cooktop does not operate properly, followthese troubleshooting steps:◊ Verify that power is being supplied to the range.◊ Check the electrical connections to ensure that theinstallation has been completed correctly.◊ Repeat the above tests.◊ If the appliance still does not work, contact DacorDistinctive Service at (800) 793-0093, extension 2822.Do not attempt to repair the appliance yourself. If youneed service, be sure to have the model and serialnumbers available when you call. See the inside coverfor location. Dacor is not responsible for the cost ofcorrecting problems caused by a faulty installation.Installation ChecklistwARNINgTo ensure a safe and proper installation, the installer mustperform the following checklist to ensure that no part of theinstallation has been overlooked. Proper installation is theresponsibility of the homeowner.1. Has the plastic coating been peeled off of the outside of therange? Have all packaging materials been removed frominside the oven?2. Are all of the legs extended down to make contact with thefloor? Is the unit level? See page 16.3. Is the range secured in place with the provided anti-tipbracket according to these instructions? See page 8 and16.4. Is the range wired and grounded according to theseinstructions and in accordance with all applicable electricalcodes? Has the electrical access cover been replaced? Seepages 3 and 10.5. Is the oven door properly installed according to theseinstructions? See page 16.6. Has proper operation been verified?7. Has the warranty been activated on-line or the warranty cardbeen filled out completely and mailed?Cooktop ControlsON/OFFON indicatorLOW MED HIGHPower level