Daewoo DV-S137WN Owner's Manual

Contents

Daewoo DV-S137WN Owner's Manual Manual pdf 19 page image

18VIDEO CHANNEL SETTINGŒTurn on your TV.´Connect the ANT.IN jack on the rear panel of TV by using the RFcable.ˇTurn on the VCP to display the “ ” red color indicator on thepanel.¨Press the “RF OUT CH” key on the remote control.The testpattern will be transmitted to the UHF 36 CH.ˆTune the VCP into the test pattern channel by pressing theChannel key on your TV’s remote control.ØTune into the channel where the interference channel is theleast.∏Tune the UHF channel by pressing the “TRK+/-” key until the testpattern appear.”Press the “RF OUT CH” key to memory the changed UHF channel.ŒTurn on your TV.´Connect the ANT.IN jack on the rear panel of TV by using the RFcable.ˇPlayback the tape.¨Tune the UHF channel 36. If the sound is poor,set the RF OUTsystem by pressing the “RF OUT SYS” key on the remote control,the system will be rotated as follows.* CAUTION1 : PAL-G is no display.* CAUTION2 : For VCP RF OUT Channel Setting, be sure to pressthe TV/VCR key and check if VCR indicator is turnedoff from the display panel.VCP RF OUT CHANNEL SETTING VCP RF OUT SYSTEM SETTINGThe built-in RF converter permits playback of video and audiorecordings through a TV receiver. The signals from the RF converterare viewed through a vacant channel not used for broadcasting inyour viewing area.The converter channel of all units is set to UHF channel 36 prior toshipment. Setting your TV receiver to UHF channel 36 may providevideo playback. But, to obtain the best possible reproduction onyour TV receiver, accurate adjustment to the RF converter output isrequired.