Dahua DHI-VTO2000-A-2-S User Manual

Dahua DHI-VTO2000-A-2-S User Manual Manual pdf 4 page image

IIIImportant Safeguards and WarningsThis chapter describes the contents covering proper handling of the device, hazard prevention,and prevention of property damage. Read these contents carefully before using the device,comply with them when using, and keep it well for future reference.Installation and Maintenance Professionals Requirements All installation and maintenance professionals must have adequate qualifications orexperiences to install and maintain CCTV systems and electric apparatus, and to workabove the ground. The professionals must have the following knowledge and operationskills: Basic knowledge and installation of CCTV systems. Basic knowledge and operation skills of low voltage wiring and low voltage electroniccircuit wire connection. Basic knowledge and operation skills of electric apparatus installation and maintenance inhazardous sites.Power Requirements Install the unit in accordance with the manufacturer’s instructions and in accordance withapplicable local codes. All installation and operation must conform to your local electrical safety codes. Do not overload outlets and extension cords, which may cause fire or electrical shock. Do not place the camera near or in a place where the camera may contact overheadpower lines, power circuits, or electrical lights. Ensure power conforms to SELV (Safety Extra Low Voltage) and that the limited powersource is rated AC 24V as specified in IEC60950-1. (Power supply requirement is subjectto the device label). All input/output ports are SELV circuits. Ensure that SELV circuits are connected only toother SELV circuits. Ground the unit using the ground connection of the power supply to protect the unit fromdamage, especially in damp environments. Please install easy-to-use device for power off before installing wiring, which is foremergent power off when necessary. Protect the plug and power cord from foot traffic, being pinched, and its exit from the unit. Do not attempt to service the unit. Opening or removing covers may expose you todangerous voltage or other hazards. Refer all servicing to qualified personnel. If the unit is damaged and requires service, unplug the unit from the main AC powersupply and from the PoE supply and refer to qualified service personnel. Damage mayinclude, but is not limited to:The power supply cord or plug is damaged.Liquid has spilled in or on the unit.An object has fallen on the unit.The unit has been dropped and the housing is damaged.