HDCVR- 63 -NetworkNetwork TestFigure 3- 62Network test interface is shown。 Destination IP: Please input valid IPV4 address or domain name. Test: Click it to test the connection with the destination IP address. The test results candisplayaverage delay and packet loss rate and you can also view the network status as OK, bad,noconnection and etc Network Sniffer backup: Please insert USB2.0 device and click the Refresh button, you can viewthedevice on the following column. You can use the dropdown list to select peripheral device.ClickBrowse button to select the snap path. The steps here are same as preview backup operation.You can view all connected network adapter names (including Ethernet, PPPoE, WIFI, and 3G), you canclickthe buttonon the right panel to begin Sniffer. Click the grey stop button to stop. Please note.system can notSniffer several network adapters at the same time.After Sniffer began, you can exit to implementcorresponding network operation such as login WEBmonitor. Please go back to Sniffer interface to clickstopSniffer. System can save the packets to thespecified path. The file is named after “Network adaptername+time”. You can use software such asWireshark to open the packets on the PC for the professionalengineer to solve complicated problems.Network LoadNetwork load is shown as in Figure 4-44. Here you can view the follow statistics of the device networkadapter.