Dahua NVR100 SERIES User Manual

Also see for NVR100 series: User manual User manual User manual User manual User manual

Contents

Dahua NVR100 SERIES User Manual Manual pdf 259 page image

246Note： The uploaded file is for sub stream only. Please go to record control interface (mainstream->setting->Storage->Record) and then select sub stream. The easy space function uses upload bandwidth. Usually the recommended upload bandwidth shallbe more than 512kbps and please make sure the network is stable. The easy space upload data adopts safe SSL encryption connection. Please enable 1-channel toupload in case this function occupies too much CPU.4.14.1.18 SWITCHIt is for you to set IP address, subnet mask, gateway and etc of the Switch. See Figure 4-143.Figure 4-1434.14.2 Network TestIn this interface, you can see network test and network load information.4.14.2.1 Network TestFrom main menu->Info-Network->Test, the network test interface is shown as in Figure 4-144. Destination IP: Please input valid IPV4 address and domain name. Test: Click it to test the connection with the destination IP address. The test results can displayaverage delay and packet loss rate and you can also view the network status as OK, bad, noconnection and etc. Network Sniffer backup: Please insert USB2.0 device and click the Refresh button, you can view thedevice on the following column. You can use the dropdown list to select peripheral device. ClickBrowse button to select the snap path. The steps here are same as preview backup operation.