Dahua VTH5221DW-C User Manual

Also see for VTH5221D: User manual User manual Setup Instruction

Dahua VTH5221DW-C User Manual Manual pdf 23 page image

Parameter NoteZone Set detector zone no.Type According to each zone detector type, select zone type, including IR,gas, smoke sensor and etc.NO/NC Set detector NO or NC.AlarmStatusInstant alarm：once prompt tone stops, it enters arming.Delay alarm：it enters arming when delay time ends.Bypass：this zone is shielded during current arming. When disarm, itrestore non-bypass status.Remote：This zone is shielded during arming and disarming.EnterDelayAfter disarming is set, it delay by this set time before disarming.Exit Delay After arming is set, it delay by this set time before alarming.Chart 5-15.2.4 ModeGo to Setting/Mode, set switch status of each zone under each mode, including stay, away,sleep and custom. See Figure 5-6.Note:You can set zone switch status for each mode in disarming status only.Figure 5-6