Dahua VTO12 Series User Manual

Also see for VTO12 Series: User manual

Dahua VTO12 Series User Manual Manual pdf 27 page image

224.1.2 Configure Digital VTHEnter digital VTH system settings—Project Settings, input project password: 002236 toenter. Input the room no. that configured on VTO. In Network Config, configure VTH IP,Subnet Mask and Default Gateway. At network terminal, input VTO IP address, enable itand click on OK.4.1.3 Create Digital SystemConnect VTO to VTH. Make VTO’s network port connect to IN port on switch. (No. 2 portin Figure 2-2 in Appendix 2). Connect any one port from port 1-6 to VTH. Check if theconnection is correct. Turn on the switch, and the switch starts to supply the VTH withpower. When the entire system boots up successfully, the VTH will automatically registerthe VTO. The offline icon at the upper left corner of VTH will disappear and VTO middle no.will be displayed at network terminal. Now, press monitor button on VTH, you can monitorimage from VTO. The digital system is complete.4.2 Debug Analog SystemSee Figure 4- 2.Figure 4- 2