3CAUTIONTo avoid electric shocks due to entry of water or insects, fill the wiring through hole with putty.Do not operate with wet hands to avoid electric shocks.Do not wash the remote controller with water.It may result in electric shocks or a fire.Install the air conditioner, power supply wiring, remote controller wiring and transmission wiring atleast 1 meter away from televisions or radios to prevent image interference or noise.(Depending on the radio waves, a distance of 1 meter may not be sufficient to eliminate the noise.)Do not install the remote controller in the following locations:1. Where there is oil mist, oil spray or vapour for example a kitchen.Resin parts may deteriorate and fall off.2. Where corrosive gas, such as sulphurous acid gas, is produced.3. Where there is machinery which emits electromagnetic waves.Electromagnetic waves may disturb the control system, and cause a malfunction of theequipment.4. Where flammable gas may leak, where there is carbon fibre or ignitable dust suspensions inthe air, or where volatile flammables such as thinner or gasoline are handled.Operating the unit in such conditions may result in a fire.5. High temperature area or directly flamed point.It may cause an overheat or a fire.6. Moist area, or place where may be exposed to water.If water enters inside of the remote controller, electrical components may fail.It may result in electric shocks or a fire.When remote controller’s thermostat sensor is used, select the installation location considering thefollowings.• A place where average temperature in the room can be detected.• A place where is not exposed to direct sunlight.• A place where is far apart from heat source.• A place where is not affected by outdoor air due to door opening/closing or the like.AccessoriesThe following accessories are included.Cross recessed roundhead wood screw Drywall anchor Operation Handbook Installation Handbook(2 pcs.) (2 pcs.) (1 pc.) (1 pc.)