5■ Outdoor Unit■ Indoor Unit1. Air filter2. Titanium Apatite PhotocatalyticAir-Purifying Filter:• These filters are attached to the inside ofthe air filters.3. Air inlet4. Front panel5. Supporting plate:• The supporting plate is used to support thefront panel during maintenance.6. Panel tab7. Flap (horizontal blade): (page 12.)8. Air outlet9. Louvers (vertical blades):• The louvers are inside of the air outlet.(page 12.)10. Outlet vent panel11. Display12. Indoor Unit ON/OFF switch: (page 10.)• Push this switch once to start operation.Push once again to stop it.• The operation mode refers to the followingtable.• This switch is useful when the remote controlleris missing.13. Room temperature sensor:• It senses the air temperature around the unit.14. Operation lamp (green)15. TIMER lamp (yellow): (page 18.)16. INTELLIGENT EYE lamp (green) : (page 16.)17. INTELLIGENT EYE sensor:• It detects the movements of people and auto-matically switches between normal operationand energy saving operation. (page 16.)18. Signal receiver:• It receives signals from the remote controller.• When the unit receives a signal, you will hear ashort beep.• Operation start .............beep-beep• Settings changed..........beep• Operation stop ..............beeeeep■ Outdoor Unit19. Air inlet: (Back and side)20. Air outlet21. Refrigerant piping and inter-unit cable22. Drain hose23. Earth terminal:• It is inside of this cover.Appearance of the outdoor unit may differ from some models.