English 22. NAMES AND FUNCTIONSOF THE OPERATING SEC-TION (Fig. 1, 2)1DISPLAY “ ” (SIGNALTRANSMISSION)This lights up when a signal is beingtransmitted.2DISPLAY “ ” “ ” “ ” “ ”“ ” (OPERATION MODE)This display shows the current OPER-ATION MODE. For straight coolingtype, “ ” (Auto) and “ ” (Heating)are not installed.3DISPLAY “ ” (SET TEMPERATURE)This display shows the set tempera-ture.4DISPLAY “ ”(PROGRAMMED TIME)This display shows PROGRAMMEDTIME of the system start or stop.5 DISPLAY “ ” (AIR FLOW FLAP)Refer to page 7.6 DISPLAY “ ” “ ” (FAN SPEED)The display shows the set fan speed.7DISPLAY “ ”(INSPECTION/ TEST OPERATION)When the INSPECTION/TEST OPER-ATION BUTTON is pressed, the displayshows the system mode is in.8ON/OFF BUTTONPress the button and the system willstart. Press the button again and thesystem will stop.9FAN SPEED CONTROL BUTTONPress this button to select the fanspeed, HIGH or LOW, of your choice.MH LChr. hr.TEST10TEMPERATURE SETTING BUTTONUse this button for SETTING TEMPER-ATURE (Operates with the front coverof the remote controller closed.)11PROGRAMMING TIMER BUTTONUse this button for programming“START and/or STOP” time. (Operateswith the front cover of the remote con-troller opened.)12 TIMER MODE START/STOP BUTTONRefer to page 7.13 TIMER RESERVE/CANCEL BUTTONRefer to page 8.14AIR FLOW DIRECTION ADJUSTBUTTONRefer to page 7.15OPERATION MODE SELECTORBUTTONPress this button to select OPERATIONMODE.16FILTER SIGN RESET BUTTONRefer to the section of MAINTENANCEin the operation manual attached to theindoor unit.17INSPECTION/TEST OPERATIONBUTTONThis button is used only by qualifiedservice persons for maintenancepurposes.18EMERGENCY OPERATION SWITCHThis switch is readily used if the remotecontroller does not work.19RECEIVERThis receives the signals from theremote controller.20OPERATING INDICATOR LAMP(Red)This lamp stays lit while the airconditioner runs. It flashes when theunit is in trouble.21 TIMER INDICATOR LAMP (Green)This lamp stays lit while the timer is set.