English 6[CAUTIONS]• Replace all batteries at the same time, do notuse new and old batteries intermixed.• In case the remote controller is not used for along time take out all batteries in order to pre-vent liquid leak of the battery.IN THE CASE OF CENTRALIZEDCONTROL SYSTEMIf the indoor unit is under centralized control, it isnecessary to switch the remote controller’s setting.In this case, contact your local dealer.If the temperature or the humidity is beyond theoperation range*, safety devices may work and theair conditioner may not operate, or sometimes,water may drop from the indoor unit.* Refer to the operation range shown in the opera-tion manual attached to the indoor or outdoor unit.Refer to the operation manual attached to the indoorunit.Refer to Fig. 1 on page [1]• Operation procedure varies with heat pump typeand cooling only type. Contact your local dealer toconfirm your system type.• To protect the unit, turn on the main power switch6 hours before operation.• Do not shut off the power supply during seasonaluse of the air conditioner.This is required in order to activate the air condi-tioner smoothly.• If the main power supply is turned off during oper-ation, operation will restart automatically after thepower turns back on again.Operate in the following order.• AUTOMATIC OPERATION can be selected onlyby Heat pump split system and VRV Heat recov-ery system.• For cooling only type, “COOLING”, and “FAN” and“PROGRAM DRY” operation are able to select.Refer to Fig. 1-1, 2 on page [1]OPERATION MODESELECTORPress OPERATION MODE SELECTOR BUT-TON several times and select the OPERA-TION MODE of your choice as follows.■ COOLING OPERATION .................................“ ”The recommended temperature setting is 26 to28°C.■ HEATING OPERATION ..................................“ ”The recommended temperature setting is 18 to23°C.■ AUTOMATIC OPERATION.............................“ ”• In this operation mode, COOLING/HEATINGchangeover is automatically conducted.• The AUTOMATIC OPERATION controls thetemperature based on the temperature setting,so it maintains a comfortable temperaturethroughout the year, and enables energy-sav-ing operation.When the indoor temperature decreases to25°C or less when the temperature setting is at27°C in the AUTOMATIC COOLING OPERA-TION, the operation is changed over to theAUTOMATIC HEATING OPERATION. Whenthe indoor temperature reaches 29°C or more,the operation is changed over to the AUTO-MATIC COOLING OPERATION.■ FAN OPERATION ...........................................“ ”Air in the room is circulated.■ PROGRAM DRY OPERATION .......................“ ”• The function of this program is to decrease thehumidity in your room with the minimum tem-perature decrease.• Micro computer automatically determinesTEMPERATURE and FAN SPEED.• This system does not go into operation if theroom temperature is below 16°C.ON/OFFPress ON/OFF BUTTONOPERATING INDICATOR LAMP (Red) lights up orgoes off and the system starts or stops OPERA-TION.• When the HEATING OPERATION is stopped,FAN OPERATION is performed for 1 minute toremove heat in the indoor unit.5. OPERATION RANGE6. INSTALLATION SITE7. OPERATION PROCEDURECOOLING, HEATING, AUTOMATIC, FAN,AND PROGRAM DRY OPERATION1 MODE2 ON OFF