SiBE12-908 Control SpecificationFunction and Control 333.5 Discharge Pipe Temperature ControlOutline The discharge pipe temperature is used as the compressor's internal temperature. If thedischarge pipe temperature rises above a certain level, the operating frequency upper limit isset to keep this temperature from going up further.Detail Divide the ZoneManagement within the Zones3.6 Input Current ControlOutline Detect an input current by the CT during the compressor is running, and set the frequencyupper limit from such input current.In case of heat pump model, this control is the upper limit control function of the frequencywhich takes priority of the lower limit of four way valve activating compensation.Detail The frequency control will be made within the following zones.When a “stop current” continues for 2.5 seconds after rushing on the stop zone, the compressoroperation stops.If a “drooping current” is continues for 1.0 second after rushing on the drooping zone, thefrequency will be 2 Hz drooping.Repeating the above drooping continues until the current rushes on the drooping zone withoutchange.In the keep zone, the frequency limit will remain.In the return / reset zone, the frequency limit will be cancelled.Limitation of current drooping and stop value according to the outdoor air temperature1. In case the operation mode is cooling The current droops when outdoor air temperature becomes higher than a certain level(model by model).2. In case the operation mode is heating (only for heat pump model) The current droops when outdoor air temperature becomes higher than a certain level(model by model).Zone Control contentsStop zone When the temperature reaches the stop zone, stop the compressor andcorrect abnormality.Drooping zone Start the timer, and the frequency will be drooping.Keep zone Keep the upper limit of frequency.Return / Reset zone Cancel the upper limit of frequency.ABCD(R2836)ABCD110103102101Keep
