Instruction Si04-60466 System Configuration211. Open the front panel.• Open the front panel by placing a finger on thepanel tab on either side of the front panel and thensecure it using the supporting plate on the right.2. Pull out the air filters.• Push a little upwards the tab at the center ofeach air filter, then pull it down.3. Take off the Titanium ApatitePhotocatalytic Air-Purifying Filter.• Hold the recessed parts of the frame andunhook the four claws.4. Clean or replace each filter.See figure.5. Set the air filter and the Titanium ApatitePhotocatalytic Air-Purifying Filter as theywere and close the front panel.• Be sure to insert the two tabs below.• Return the supporting plate to its previous position.• Press either side of the front panel. Air Filter1. Wash the air filters with water or clean them withvacuum cleaner.• If the dust does not come off easily, wash them with neutral detergentthinned with lukewarm water, then dry them up in the shade.• It is recommended to clean the air filters every two weeks. Titanium Apatite PhotocatalyticAir-Purifying Filter (gray)The Titanium Apatite Photocatalytic Air-Purifying Filter can be renewedby washing it with water once every 6 months. We recommend replacing it once every 3 years.[ Maintenance ]1. Remove dust with a vacuum cleaner and wash lightly with water.2. If it is very dirty, soak it for 10 to 15 minutes in water mixed with a neutral cleaning agent.3. Do not remove filter from frame when washing with water.4. After washing, shake off remaining water and dry in the shade.5. Since the material is made out of paper, do not wring out the filter when removing water from it.[ Replacement]1. Remove the tabs on the filter frame and replace with a new filter.• Dispose of the old filter as flammable waste.Filters
