Daikin FAA71AUVEB Installation Manual

Also see for FAA100AUVEB: Operation manual Technical data

Contents

English 9< How to attach the front grille (for 100 class only) >Attach the screw cover (6) provided with the air outlet. (3 places)• Remove the drain plug, the insulation tubing, and the drain hose from the drain pan and replace.(Refer to Fig. 10)• Mold the local refrigerant piping ahead of time, matching it to the liquid pipe and gas pipe marksengraved on the installation panel (1).< Replacing the drain hose and drain plug >(1) Remove the drain plug and insulating tube.(2) Remove the drain hose installation screws, and pull out the drain hose.(3) Replace the drain plug and the insulating tube onto the right side.(4) Replace the drain hose onto the left side, and secure the hose with the installation screws.If the drain hose is not replaced, water is likely to be accumulated inside the unit. The occurrence of slime mayclog the hose and cause water leakage.(4) Hook the indoor unit onto the installation plate. (Refer to Fig. 11)• Placing buffering material between the wall and the indoor unit at this time will make work easier.For right, bottom-right, and back-right piping• Pass the drain hose and the refrigerant piping to the wall.Drain plugInsulating tubeFig. 10Do not place lubricant (refrigerant oil) when inserting.This may cause deterioration and water leaks.Insert using a hexagon wrench (4mm).Make surethere areno gaps.Refrigerant pipeBe sure to pass all wires throughthe wiring guide.TabThere are 2 places for 71 class.There are 3 places for 100 class.Wiring (locally procured)Wiring the units, Earth wiring,Remote controller wiringInstallation plate (1)(accessory)Front panel Front grilleControl box coverPlace buffering materialHook the indoor unit hook onto the installation plate (1).Fig. 11WallDrain hose