English 148. HOW TO CONNECT WIRINGS AND WIRING EXAMPLE8-1 HOW TO CONNECT WIRINGSMethods of wiring units and connecting remote controller wiring• Wiring between unitsUnscrew and remove the service lid.Connect the wiring between units of matching number to the power supply terminal block (4P). And connectthe ground wiring to the ground terminal.When doing this, tie the wiring between units and the ground wiring using the included clamp (small) (5) andthen firmly secure using the included clamp (small) (5) according to the figure.(Refer to Fig. 20)• Remote controller wiringUnscrew and remove the service lid.Connect the remote controller wiring to the terminal block (5P).When doing this, tie the remote controller wiring using the included clamp (small) (5) and then firmly secureusing the included clamp (small) (5) according to the figure. (Refer to Fig. 20)1 2 3REMOTECNTRL TRANSMISSIONWIRINGF1 F2P1 P2Fig. 20In case of using the powersupply terminal together withthe other connecting wiringsMake sure to processthe insulation at the wireterminal part properly so thatthe terminals do not get incontact each other.1 2 3Ground wiringWiring between units< Wiring clamp method >Clamp small (accessory) (5)Clamp small (accessory) (5)Clamp after tying thewiring between the unitsand the ground wiring.Remote controllercode(Wiring between unit)How to connect powersupply terminal block(4P)123123OutdoorunitIndoorunitTerminal blockfor the remotecontroller (5P)Ground terminalGround wiringWiring the unitsPower supplyterminal block (4P)Remote controller wiringClamp small (accessory) (5)(3 places)Cut off any excessmaterial after tightening.